[PATCH 8/8] ARM: dts: iwg20d-q7-dbcm-ca: Add can1 support to camera DB

[Fabrizio Castro]

CAN1 interface is exposed via connector J3 found on the camera daughter
board. This patch enables can1 DT node from within the daughter board
specific dtsi.

Signed-off-by: Fabrizio Castro <fabrizio.castro at bp.renesas.com>
Reviewed-by: Biju Das <biju.das at bp.renesas.com>
---
 arch/arm/boot/dts/iwg20d-q7-dbcm-ca.dtsi | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm/boot/dts/iwg20d-q7-dbcm-ca.dtsi b/arch/arm/boot/dts/iwg20d-q7-dbcm-ca.dtsi
index 4db18f2..476273b 100644
--- a/arch/arm/boot/dts/iwg20d-q7-dbcm-ca.dtsi
+++ b/arch/arm/boot/dts/iwg20d-q7-dbcm-ca.dtsi
@@ -32,6 +32,13 @@
 	};
 };
 
+&can1 {
+	pinctrl-0 = <&can1_pins>;
+	pinctrl-names = "default";
+
+	status = "okay";
+};
+
 &du {
 	pinctrl-0 = <&du_pins>;
 	pinctrl-names = "default";
@@ -94,6 +101,11 @@
 };
 
 &pfc {
+	can1_pins: can1 {
+		groups = "can1_data_d";
+		function = "can1";
+	};
+
 	du_pins: du {
 		groups = "du_rgb888", "du_sync", "du_oddf", "du_clk_out_0";
 		function = "du";
-- 
2.7.4