[PATCH 0/9] Add support for the pin controllers on the Marvell Armada 7K/8K

[Thomas Petazzoni]

Hello,

On Fri, 19 May 2017 18:04:42 +0200, Gregory CLEMENT wrote:

> Gregory CLEMENT (6):
>   MAINTAINERS: extend mvebu SoC entry with pinctrl drivers
>   pinctrl: dt-bindings: add documentation for AP806 pin controllers
>   pinctrl: dt-bindings: add documentation for CP110 pin controllers
>   pinctrl: mvebu: remove the offset property for regmap
>   arm64: marvell: enable the Armada 7K/8K pinctrl driver
>   arm64: dts: marvell: add pinctrl support for Armada 7K/8K
> 
> Hanna Hawa (2):
>   pinctrl: mvebu: add driver for Armada AP806 pinctrl
>   pinctrl: mvebu: add driver for Armada CP110 pinctrl
> 
> Russell King (1):
>   pinctrl: avoid PLAT_ORION dependency

I have tested the combination of your four series (touching clock,
pinmux and gpio) on Armada 8K MacchiatoBin, and I was able to validate
that the CP110 pinmuxing works as expected.

I used MPP37 and MPP38, which I was able to configure as GPIO or I2C0,
and validate that they are working as GPIOs and as I2C0.

I was however unable to test the AP MPPs due to the lack of access to
such pins.

Best regards,

Thomas
-- 
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com