[PATCH 3/3] ARM64: dts: Fix GXBB periphs pinctrl pull-enable register base
Jerome Brunet
jbrunet at baylibre.com
Wed May 24 01:40:05 PDT 2017
On Tue, 2017-05-23 at 16:21 +0200, Neil Armstrong wrote:
> The pull-enable register base was wrongly copied from the meson8b pinctrl
> node,
> but was not used yet.
Reviewed-by: Jerome Brunet <jbrunet at baylibre.com>
>
> Fixes: c328666d58aa ("ARM64: dts: amlogic: Add Meson GX dtsi from GXBB")
> Signed-off-by: Neil Armstrong <narmstrong at baylibre.com>
> ---
> arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi
> b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi
> index 6f8b301..47ca44d 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi
> @@ -351,7 +351,7 @@
> gpio: bank at 4b0 {
> reg = <0x0 0x004b0 0x0 0x28>,
> <0x0 0x004e8 0x0 0x14>,
> - <0x0 0x00120 0x0 0x14>,
> + <0x0 0x00520 0x0 0x14>,
> <0x0 0x00430 0x0 0x40>;
> reg-names = "mux", "pull", "pull-enable", "gpio";
> gpio-controller;
More information about the linux-arm-kernel
mailing list