[PATCH 2/2] arm64: marvell: dts: add second 1G port on the Armada 8040 DB

[Gregory CLEMENT]

Hi Marcin,
 
 On mar., mai 16 2017, Marcin Wojtas <mw at semihalf.com> wrote:

> Armada 8040 DB is equipped with 4 (2x 10G SFI + 2x 1G RGMII)
> ethernet ports of which only one was hitherto enabled.
> Because currently mvpp2 driver is capable of supporting only
> 1G RGMII/SGMII, enable second port from CP slave HW block.
>

Applied on mvebu/dt64

Thanks,

Gregory

> Signed-off-by: Marcin Wojtas <mw at semihalf.com>
> ---
>  arch/arm64/boot/dts/marvell/armada-8040-db.dts | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> index dc0d084..3cde649 100644
> --- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> +++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> @@ -169,6 +169,22 @@
>  	status = "okay";
>  };
>  
> +&cps_mdio {
> +	phy0: ethernet-phy at 0 {
> +		reg = <0>;
> +	};
> +};
> +
> +&cps_ethernet {
> +	status = "okay";
> +};
> +
> +&cps_eth1 {
> +	status = "okay";
> +	phy = <&phy0>;
> +	phy-mode = "rgmii-id";
> +};
> +
>  &ap_sdhci0 {
>  	status = "okay";
>  	bus-width = <4>;
> -- 
> 1.8.3.1
>

-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com