[PATCH 37/41] ARM: dts: am57xx-beagle-x15-common: Set MMC2 IO voltage to 3.3V
Kishon Vijay Abraham I
kishon at ti.com
Fri May 19 01:15:37 PDT 2017
MMC2 interface on AM57xx Beagle-x15, connected to
onboard eMMC, has IO voltage fixed to 3.3V.
Add no-1-8-v device-tree property to mmc2 node
in the board's device-tree file to reflect
this.
Note that the AM57xx SoC itself supports dual-voltage
on MMC2. The limitation above is due to the board.
Signed-off-by: Sekhar Nori <nsekhar at ti.com>
Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
---
arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi | 1 +
1 file changed, 1 insertion(+)
diff --git a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
index 064755e6fac5..8cef5d1460ec 100644
--- a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
+++ b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
@@ -445,6 +445,7 @@
bus-width = <8>;
ti,non-removable;
cap-mmc-dual-data-rate;
+ no-1-8-v;
};
&sata {
--
2.11.0
More information about the linux-arm-kernel
mailing list