[PATCH] irqchip/gicv3-its: skip irq affinity setting when target cpu is the same as current setting
Majun
majun258 at huawei.com
Thu May 18 01:19:13 PDT 2017
From: MaJun <majun258 at huawei.com>
Just skip the irq affinity setting when the target cpu is the same as
current setting.
This is a small optimization for irq affinity setting logic.
Signed-off-by: MaJun <majun258 at huawei.com>
---
drivers/irqchip/irq-gic-v3-its.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/irqchip/irq-gic-v3-its.c b/drivers/irqchip/irq-gic-v3-its.c
index 45ea1933..b335280 100644
--- a/drivers/irqchip/irq-gic-v3-its.c
+++ b/drivers/irqchip/irq-gic-v3-its.c
@@ -644,9 +644,12 @@ static int its_set_affinity(struct irq_data *d, const struct cpumask *mask_val,
if (cpu >= nr_cpu_ids)
return -EINVAL;
- target_col = &its_dev->its->collections[cpu];
- its_send_movi(its_dev, target_col, id);
- its_dev->event_map.col_map[id] = cpu;
+ /* don't set the affinity when the target cpu is same as current one */
+ if (cpu != its_dev->event_map.col_map[id]) {
+ target_col = &its_dev->its->collections[cpu];
+ its_send_movi(its_dev, target_col, id);
+ its_dev->event_map.col_map[id] = cpu;
+ }
return IRQ_SET_MASK_OK_DONE;
}
--
1.7.12.4
More information about the linux-arm-kernel
mailing list