[v3, 0/5] Add eSDHC UHS-I/HS200 mode support for ls1012a/ls1046a/ls208xa

[Shawn Guo]

On Tue, May 09, 2017 at 10:37:04AM +0800, Yangbo Lu wrote:
> This patchset is to add eSDHC UHS-I/HS200 mode support for ls1012a/ls1046a/ls208xa.
> Also add eSDHC node for ls1088a. Because eSDHC is not a standard SD controller,
> the specific speed mode support depends on board's peripheral circuit for eSDHC.
> So, we have to add these speed modes support on board dts file.
> 
> In additon, these dts patches depends on esdhc driver patches which just had been merged
> on mmc.git. Otherwise, the UHS-I SD card and eMMC HS200 card would fail to be initialized,
> but other cards still could work fine.
> https://patchwork.kernel.org/patch/9689875/
> https://patchwork.kernel.org/patch/9689877/
> https://patchwork.kernel.org/patch/9689879/
> https://patchwork.kernel.org/patch/9689887/
> https://patchwork.kernel.org/patch/9689885/
> 
> Yangbo Lu (5):
>   mmc: dt: add compatible into eSDHC required properties
>   arm64: dts: ls1046a: support SD UHS-I and eMMC HS200 on RDB
>   arm64: dts: ls208xa: support SD UHS-I on RDB and eMMC HS200 on QDS
>   arm64: dts: ls1012a: add eSDHC nodes
>   arm64: dts: ls1088a: add esdhc node

Applied all, thanks.