[PATCH 08/11] arm64: dts: Add GPIO DT nodes for Stingray SOC
Anup Patel
anup.patel at broadcom.com
Sat May 6 04:54:43 PDT 2017
From: Pramod Kumar <pramod.kumar at broadcom.com>
The GPIOs on Stingray SOC are based on iProc GPIOs hence
using this we add GPIO DT nodes for Stingray SOC.
Signed-off-by: Pramod Kumar <pramodku at broadcom.com>
Reviewed-by: Ray Jui <rjui at broadcom.com>
Reviewed-by: Scott Branden <sbranden at broadcom.com>
---
.../arm64/boot/dts/broadcom/stingray/stingray.dtsi | 34 ++++++++++++++++++++++
1 file changed, 34 insertions(+)
diff --git a/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi b/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
index f9a8e8d..fb51473 100644
--- a/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
+++ b/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
@@ -258,6 +258,40 @@
#include "stingray-clock.dtsi"
#include "stingray-pinctrl.dtsi"
+ gpio_crmu: gpio at 66424800 {
+ compatible = "brcm,iproc-gpio";
+ reg = <0x66424800 0x4c>;
+ ngpios = <6>;
+ #gpio-cells = <2>;
+ gpio-controller;
+ };
+
+ gpio_hsls: gpio at 689d0000 {
+ compatible = "brcm,iproc-gpio";
+ reg = <0x689d0000 0x864>;
+ ngpios = <151>;
+ #gpio-cells = <2>;
+ gpio-controller;
+ interrupt-controller;
+ interrupts = <GIC_SPI 183 IRQ_TYPE_LEVEL_HIGH>;
+ gpio-ranges = <&pinmux 0 0 16>,
+ <&pinmux 16 71 2>,
+ <&pinmux 18 131 8>,
+ <&pinmux 26 83 6>,
+ <&pinmux 32 123 4>,
+ <&pinmux 36 43 24>,
+ <&pinmux 60 89 2>,
+ <&pinmux 62 73 4>,
+ <&pinmux 66 95 28>,
+ <&pinmux 94 127 4>,
+ <&pinmux 98 139 10>,
+ <&pinmux 108 16 27>,
+ <&pinmux 135 77 6>,
+ <&pinmux 141 67 4>,
+ <&pinmux 145 149 6>,
+ <&pinmux 151 91 4>;
+ };
+
uart0: uart at 68a00000 {
device_type = "serial";
compatible = "snps,dw-apb-uart";
--
2.7.4
More information about the linux-arm-kernel
mailing list