[PATCH V8 07/11] iommu: of: Handle IOMMU lookup failure with deferred probing or error

Sricharan R sricharan at codeaurora.org
Wed May 3 03:24:59 PDT 2017


Hi Robin,

On 5/3/2017 3:24 PM, Robin Murphy wrote:
> Hi Geert,
> 
> On 02/05/17 19:35, Geert Uytterhoeven wrote:
>> Hi Sricharan,
>>
>> On Fri, Feb 3, 2017 at 4:48 PM, Sricharan R <sricharan at codeaurora.org> wrote:
>>> From: Laurent Pinchart <laurent.pinchart+renesas at ideasonboard.com>
>>>
>>> Failures to look up an IOMMU when parsing the DT iommus property need to
>>> be handled separately from the .of_xlate() failures to support deferred
>>> probing.
>>>
>>> The lack of a registered IOMMU can be caused by the lack of a driver for
>>> the IOMMU, the IOMMU device probe not having been performed yet, having
>>> been deferred, or having failed.
>>>
>>> The first case occurs when the device tree describes the bus master and
>>> IOMMU topology correctly but no device driver exists for the IOMMU yet
>>> or the device driver has not been compiled in. Return NULL, the caller
>>> will configure the device without an IOMMU.
>>>
>>> The second and third cases are handled by deferring the probe of the bus
>>> master device which will eventually get reprobed after the IOMMU.
>>>
>>> The last case is currently handled by deferring the probe of the bus
>>> master device as well. A mechanism to either configure the bus master
>>> device without an IOMMU or to fail the bus master device probe depending
>>> on whether the IOMMU is optional or mandatory would be a good
>>> enhancement.
>>>
>>> Tested-by: Marek Szyprowski <m.szyprowski at samsung.com>
>>> Signed-off-by: Laurent Pichart <laurent.pinchart+renesas at ideasonboard.com>
>>> Signed-off-by: Sricharan R <sricharan at codeaurora.org>
>>
>> This patch broke Renesas R-Car Gen3 platforms in renesas-drivers.
>> As the IOMMU nodes in DT are not yet enabled, all devices having iommus
>> properties in DT now fail to probe.
> 
> How exactly do they fail to probe? Per d7b0558230e4, if there are no ops
> registered then they should merely defer until we reach the point of
> giving up and ignoring the IOMMU. Is it just that you have no other
> late-probing drivers or post-init module loads to kick the deferred
> queue after that point? I did try to find a way to explicitly kick it
> from a suitably late initcall, but there didn't seem to be any obvious
> public interface - anyone have any suggestions?
> 
> I think that's more of a general problem with the probe deferral
> mechanism itself (I've seen the same thing happen with some of the
> CoreSight stuff on Juno due to the number of inter-component
> dependencies) rather than any specific fault of this series.
> 

I was thinking of an additional check like below to avoid the
situation ?

>From 499b6e662f60f23740b8880882b0a16f16434501 Mon Sep 17 00:00:00 2001
From: Sricharan R <sricharan at codeaurora.org>
Date: Wed, 3 May 2017 13:16:59 +0530
Subject: [PATCH] iommu: of: Fix check for returning EPROBE_DEFER

While returning EPROBE_DEFER for iommu masters
take in to account of iommu nodes that could be
marked in DT as 'status=disabled', in which case
simply return NULL and let the master's probe
continue rather than deferring.

Signed-off-by: Sricharan R <sricharan at codeaurora.org>
---
 drivers/iommu/of_iommu.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/iommu/of_iommu.c b/drivers/iommu/of_iommu.c
index 9f44ee8..e6e9bec 100644
--- a/drivers/iommu/of_iommu.c
+++ b/drivers/iommu/of_iommu.c
@@ -118,6 +118,7 @@ static bool of_iommu_driver_present(struct device_node *np)

        ops = iommu_ops_from_fwnode(fwnode);
        if ((ops && !ops->of_xlate) ||
+           !of_device_is_available(iommu_spec->np) ||
            (!ops && !of_iommu_driver_present(iommu_spec->np)))
                return NULL;

-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation


Regards,
 Sricharan


> Robin.
> 
>> This can be fixed by either:
>>   - Disabling CONFIG_IPMMU_VMSA, or
>>   - Reverting commit 7b07cbefb68d486f (but keeping "int ret = 0;").
>>
>> Note that this was a bit hard to investigate, as R-Car Gen3 support wasn't
>> upstreamed yet, so bisection pointed to a merge commit.
>>
>>> ---
>>>  [*] Fixed minor comment from Bjorn for removing the pci.h header inclusion
>>>      in of_iommu.c
>>>
>>>  drivers/base/dma-mapping.c | 5 +++--
>>>  drivers/iommu/of_iommu.c   | 4 ++--
>>>  drivers/of/device.c        | 7 ++++++-
>>>  include/linux/of_device.h  | 9 ++++++---
>>>  4 files changed, 17 insertions(+), 8 deletions(-)
>>>
>>> diff --git a/drivers/base/dma-mapping.c b/drivers/base/dma-mapping.c
>>> index 449b948..82bd45c 100644
>>> --- a/drivers/base/dma-mapping.c
>>> +++ b/drivers/base/dma-mapping.c
>>> @@ -353,6 +353,7 @@ int dma_configure(struct device *dev)
>>>  {
>>>         struct device *bridge = NULL, *dma_dev = dev;
>>>         enum dev_dma_attr attr;
>>> +       int ret = 0;
>>>
>>>         if (dev_is_pci(dev)) {
>>>                 bridge = pci_get_host_bridge_device(to_pci_dev(dev));
>>> @@ -363,7 +364,7 @@ int dma_configure(struct device *dev)
>>>         }
>>>
>>>         if (dma_dev->of_node) {
>>> -               of_dma_configure(dev, dma_dev->of_node);
>>> +               ret = of_dma_configure(dev, dma_dev->of_node);
>>>         } else if (has_acpi_companion(dma_dev)) {
>>>                 attr = acpi_get_dma_attr(to_acpi_device_node(dma_dev->fwnode));
>>>                 if (attr != DEV_DMA_NOT_SUPPORTED)
>>> @@ -373,7 +374,7 @@ int dma_configure(struct device *dev)
>>>         if (bridge)
>>>                 pci_put_host_bridge_device(bridge);
>>>
>>> -       return 0;
>>> +       return ret;
>>>  }
>>>
>>>  void dma_deconfigure(struct device *dev)
>>> diff --git a/drivers/iommu/of_iommu.c b/drivers/iommu/of_iommu.c
>>> index 1f92d98..2d04663 100644
>>> --- a/drivers/iommu/of_iommu.c
>>> +++ b/drivers/iommu/of_iommu.c
>>> @@ -236,7 +236,7 @@ const struct iommu_ops *of_iommu_configure(struct device *dev,
>>>                         ops = ERR_PTR(err);
>>>         }
>>>
>>> -       return IS_ERR(ops) ? NULL : ops;
>>> +       return ops;
>>>  }
>>>
>>>  static int __init of_iommu_init(void)
>>> @@ -247,7 +247,7 @@ static int __init of_iommu_init(void)
>>>         for_each_matching_node_and_match(np, matches, &match) {
>>>                 const of_iommu_init_fn init_fn = match->data;
>>>
>>> -               if (init_fn(np))
>>> +               if (init_fn && init_fn(np))
>>>                         pr_err("Failed to initialise IOMMU %s\n",
>>>                                 of_node_full_name(np));
>>>         }
>>> diff --git a/drivers/of/device.c b/drivers/of/device.c
>>> index c17c19d..ba51ca6 100644
>>> --- a/drivers/of/device.c
>>> +++ b/drivers/of/device.c
>>> @@ -82,7 +82,7 @@ int of_device_add(struct platform_device *ofdev)
>>>   * can use a platform bus notifier and handle BUS_NOTIFY_ADD_DEVICE events
>>>   * to fix up DMA configuration.
>>>   */
>>> -void of_dma_configure(struct device *dev, struct device_node *np)
>>> +int of_dma_configure(struct device *dev, struct device_node *np)
>>>  {
>>>         u64 dma_addr, paddr, size;
>>>         int ret;
>>> @@ -129,10 +129,15 @@ void of_dma_configure(struct device *dev, struct device_node *np)
>>>                 coherent ? " " : " not ");
>>>
>>>         iommu = of_iommu_configure(dev, np);
>>> +       if (IS_ERR(iommu))
>>> +               return PTR_ERR(iommu);
>>> +
>>>         dev_dbg(dev, "device is%sbehind an iommu\n",
>>>                 iommu ? " " : " not ");
>>>
>>>         arch_setup_dma_ops(dev, dma_addr, size, iommu, coherent);
>>> +
>>> +       return 0;
>>>  }
>>>  EXPORT_SYMBOL_GPL(of_dma_configure);
>>>
>>> diff --git a/include/linux/of_device.h b/include/linux/of_device.h
>>> index 3cb2288..9499861 100644
>>> --- a/include/linux/of_device.h
>>> +++ b/include/linux/of_device.h
>>> @@ -56,7 +56,7 @@ static inline struct device_node *of_cpu_device_node_get(int cpu)
>>>         return of_node_get(cpu_dev->of_node);
>>>  }
>>>
>>> -void of_dma_configure(struct device *dev, struct device_node *np);
>>> +int of_dma_configure(struct device *dev, struct device_node *np);
>>>  void of_dma_deconfigure(struct device *dev);
>>>  #else /* CONFIG_OF */
>>>
>>> @@ -105,8 +105,11 @@ static inline struct device_node *of_cpu_device_node_get(int cpu)
>>>  {
>>>         return NULL;
>>>  }
>>> -static inline void of_dma_configure(struct device *dev, struct device_node *np)
>>> -{}
>>> +
>>> +static inline int of_dma_configure(struct device *dev, struct device_node *np)
>>> +{
>>> +       return 0;
>>> +}
>>>  static inline void of_dma_deconfigure(struct device *dev)
>>>  {}
>>>  #endif /* CONFIG_OF */
>>
>> Gr{oetje,eeting}s,
>>
>>                         Geert
>>
>> --
>> Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert at linux-m68k.org
>>
>> In personal conversations with technical people, I call myself a hacker. But
>> when I'm talking to journalists I just say "programmer" or something like that.
>>                                 -- Linus Torvalds
>>
> 

-- 
"QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation



More information about the linux-arm-kernel mailing list