[PATCH v3 2/2] PCI: Add tango PCIe host bridge support
Robin Murphy
robin.murphy at arm.com
Wed Mar 29 05:19:42 PDT 2017
On 29/03/17 12:34, Marc Gonzalez wrote:
> This driver is used to work around HW bugs in the controller.
>
> Note: the controller does NOT support the following features.
>
> Legacy PCI interrupts
> IO space
>
> Signed-off-by: Marc Gonzalez <marc_gonzalez at sigmadesigns.com>
> ---
> Documentation/devicetree/bindings/pci/tango-pcie.txt | 33 +++++++++
> drivers/pci/host/Kconfig | 7 ++
> drivers/pci/host/Makefile | 1 +
> drivers/pci/host/pcie-tango.c | 150 +++++++++++++++++++++++++++++++++++++++
> 4 files changed, 191 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/pci/tango-pcie.txt b/Documentation/devicetree/bindings/pci/tango-pcie.txt
> new file mode 100644
> index 000000000000..f8e150ec41d8
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/pci/tango-pcie.txt
> @@ -0,0 +1,33 @@
> +Sigma Designs Tango PCIe controller
> +
> +Required properties:
> +
> +- compatible: "sigma,smp8759-pcie"
> +- reg: address/size of PCI configuration space, and pcie_reg
> +- bus-range: defined by size of PCI configuration space
> +- device_type: "pci"
> +- #size-cells: <2>
> +- #address-cells: <3>
> +- #interrupt-cells: <1>
> +- ranges: translation from system to bus addresses
> +- interrupts: spec for misc interrupts and MSI
> +- msi-controller
> +
> +Example:
> +
> + pcie at 2e000 {
> + compatible = "sigma,smp8759-pcie";
> + reg = <0x50000000 SZ_64M>, <0x2e000 0x100>;
> + bus-range = <0 63>;
> + device_type = "pci";
> + #size-cells = <2>;
> + #address-cells = <3>;
> + #interrupt-cells = <1>;
> + /* http://elinux.org/Device_Tree_Usage#PCI_Address_Translation */
> + /* BUS_ADDRESS(3) CPU_PHYSICAL(1) SIZE(2) */
> + ranges = <0x02000000 0x0 0x04000000 0x54000000 0x0 SZ_192M>;
> + interrupts =
> + <54 IRQ_TYPE_LEVEL_HIGH>, /* misc interrupts */
> + <55 IRQ_TYPE_LEVEL_HIGH>; /* MSI */
> + msi-controller;
> + };
> diff --git a/drivers/pci/host/Kconfig b/drivers/pci/host/Kconfig
> index d7e7c0a827c3..8a622578a760 100644
> --- a/drivers/pci/host/Kconfig
> +++ b/drivers/pci/host/Kconfig
> @@ -285,6 +285,13 @@ config PCIE_ROCKCHIP
> There is 1 internal PCIe port available to support GEN2 with
> 4 slots.
>
> +config PCIE_TANGO
> + tristate "Tango PCIe controller"
> + depends on ARCH_TANGO && PCI_MSI && OF
> + select PCI_HOST_COMMON
> + help
> + Say Y here to enable PCIe controller support on Tango SoC.
Nit: in line with the other help texts, that could probably benefit from
a wee bit more context (i.e. "Sigma Designs Tango SoCs")
> +
> config VMD
> depends on PCI_MSI && X86_64
> tristate "Intel Volume Management Device Driver"
> diff --git a/drivers/pci/host/Makefile b/drivers/pci/host/Makefile
> index 084cb4983645..fc7ea90196f3 100644
> --- a/drivers/pci/host/Makefile
> +++ b/drivers/pci/host/Makefile
> @@ -32,4 +32,5 @@ obj-$(CONFIG_PCI_HOST_THUNDER_PEM) += pci-thunder-pem.o
> obj-$(CONFIG_PCIE_ARMADA_8K) += pcie-armada8k.o
> obj-$(CONFIG_PCIE_ARTPEC6) += pcie-artpec6.o
> obj-$(CONFIG_PCIE_ROCKCHIP) += pcie-rockchip.o
> +obj-$(CONFIG_PCIE_TANGO) += pcie-tango.o
> obj-$(CONFIG_VMD) += vmd.o
> diff --git a/drivers/pci/host/pcie-tango.c b/drivers/pci/host/pcie-tango.c
> index e88850983a1d..dbc2663486b5 100644
> --- a/drivers/pci/host/pcie-tango.c
> +++ b/drivers/pci/host/pcie-tango.c
> @@ -192,3 +192,153 @@ static int tango_msi_probe(struct platform_device *pdev, struct tango_pcie *pcie
>
> return 0;
> }
> +
> +/*** HOST BRIDGE SUPPORT ***/
> +
> +static int smp8759_config_read(struct pci_bus *bus,
> + unsigned int devfn, int where, int size, u32 *val)
> +{
> + int ret;
> + struct pci_config_window *cfg = bus->sysdata;
> + struct tango_pcie *pcie = dev_get_drvdata(cfg->parent);
> +
> + /*
> + * QUIRK #1
> + * Reads in configuration space outside devfn 0 return garbage.
> + */
> + if (devfn != 0) {
> + *val = ~0; /* Is this required even if we return an error? */
> + return PCIBIOS_FUNC_NOT_SUPPORTED; /* Error seems appropriate */
> + }
> +
> + /*
> + * QUIRK #2
> + * The root complex advertizes a fake BAR, which is used to filter
> + * bus-to-system requests. Hide it from Linux.
> + */
> + if (where == PCI_BASE_ADDRESS_0 && bus->number == 0) {
> + *val = 0; /* 0 or ~0 to hide the BAR from Linux? */
> + return PCIBIOS_SUCCESSFUL; /* Should we return error or success? */
> + }
> +
> + /*
> + * QUIRK #3
> + * Unfortunately, config and mem spaces are muxed.
> + * Linux does not support such a setting, since drivers are free
> + * to access mem space directly, at any time.
> + * Therefore, we can only PRAY that config and mem space accesses
> + * NEVER occur concurrently.
> + */
What about David's suggestion of using an IPI for safe mutual exclusion?
> + writel_relaxed(1, pcie->mux);
> + ret = pci_generic_config_read(bus, devfn, where, size, val);
> + writel_relaxed(0, pcie->mux);
> +
> + return ret;
> +}
> +
> +static int smp8759_config_write(struct pci_bus *bus,
> + unsigned int devfn, int where, int size, u32 val)
> +{
> + int ret;
> + struct pci_config_window *cfg = bus->sysdata;
> + struct tango_pcie *pcie = dev_get_drvdata(cfg->parent);
> +
> + writel_relaxed(1, pcie->mux);
> + ret = pci_generic_config_write(bus, devfn, where, size, val);
> + writel_relaxed(0, pcie->mux);
> +
> + return ret;
> +}
> +
> +static struct pci_ecam_ops smp8759_ecam_ops = {
> + .bus_shift = 20,
> + .pci_ops = {
> + .map_bus = pci_ecam_map_bus,
> + .read = smp8759_config_read,
> + .write = smp8759_config_write,
> + }
> +};
> +
> +static const struct of_device_id tango_pcie_ids[] = {
> + { .compatible = "sigma,smp8759-pcie" },
General tip: use your .data member here...
> + { /* sentinel */ },
> +};
> +
> +static void smp8759_init(struct tango_pcie *pcie, void __iomem *base)
> +{
> + pcie->mux = base + 0x48;
> + pcie->msi_status = base + 0x80;
> + pcie->msi_mask = base + 0xa0;
> + pcie->msi_doorbell = 0xa0000000 + 0x2e07c;
> +}
> +
> +static int tango_pcie_probe(struct platform_device *pdev)
> +{
> + int ret;
> + void __iomem *base;
> + struct resource *res;
> + struct tango_pcie *pcie;
> + struct device *dev = &pdev->dev;
> +
> + pcie = devm_kzalloc(dev, sizeof(*pcie), GFP_KERNEL);
> + if (!pcie)
> + return -ENOMEM;
> +
> + platform_set_drvdata(pdev, pcie);
> +
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
> + base = devm_ioremap_resource(&pdev->dev, res);
> + if (IS_ERR(base))
> + return PTR_ERR(base);
> +
> + if (of_device_is_compatible(dev->of_node, "sigma,smp8759-pcie"))
> + smp8759_init(pcie, base);
...then retrieve it with of_device_get_match_data() here. No need to
reinvent the wheel (or have to worry about the ordering of multiple
compatibles once rev. n+1 comes around).
> +
> + ret = tango_msi_probe(pdev, pcie);
> + if (ret)
> + return ret;
> +
> + return pci_host_common_probe(pdev, &smp8759_ecam_ops);
> +}
> +
> +static int tango_pcie_remove(struct platform_device *pdev)
> +{
> + return tango_msi_remove(pdev);
> +}
> +
> +static struct platform_driver tango_pcie_driver = {
> + .probe = tango_pcie_probe,
> + .remove = tango_pcie_remove,
> + .driver = {
> + .name = KBUILD_MODNAME,
> + .of_match_table = tango_pcie_ids,
> + },
> +};
> +
> +module_platform_driver(tango_pcie_driver);
> +
> +#define VENDOR_SIGMA 0x1105
Should this not be in include/linux/pci_ids.h?
Robin.
> +
> +/*
> + * QUIRK #4
> + * The root complex advertizes the wrong device class.
> + * Header Type 1 is for PCI-to-PCI bridges.
> + */
> +static void tango_fixup_class(struct pci_dev *dev)
> +{
> + dev->class = PCI_CLASS_BRIDGE_PCI << 8;
> +}
> +DECLARE_PCI_FIXUP_EARLY(VENDOR_SIGMA, PCI_ANY_ID, tango_fixup_class);
> +
> +/*
> + * QUIRK #5
> + * Only transfers within the root complex BAR are forwarded to the host.
> + * By default, the DMA framework expects that
> + * PCI address 0x8000_0000 maps to system address 0x8000_0000
> + * which is where DRAM0 is mapped.
> + */
> +static void tango_fixup_bar(struct pci_dev *dev)
> +{
> + pci_write_config_dword(dev, PCI_BASE_ADDRESS_0, 0x80000000);
> +}
> +DECLARE_PCI_FIXUP_FINAL(VENDOR_SIGMA, PCI_ANY_ID, tango_fixup_bar);
>
More information about the linux-arm-kernel
mailing list