[PATCH v5 0/8] Add dual-role OTG support for Allwinner H3
maxime.ripard at free-electrons.com
Mon Mar 27 04:47:18 PDT 2017
On Mon, Mar 27, 2017 at 03:35:25PM +0530, Kishon Vijay Abraham I wrote:
> On Saturday 25 March 2017 08:20 PM, Icenowy Zheng wrote:
> > Allwinner H3 have a its USB PHY0 routed to two USB controllers: one is
> > a MUSB controller, which can work in peripheral mode, but works badly in
> > host mode (several hardware will fail on the MUSB controller, even connect
> > one MUSB controller in peripheral mode to another one in host mode cannot
> > work); the other is a pair of EHCI/OHCI controller, which can work only
> > in host mode, but have better compatibillity. The route is controlled in
> > a register, which we have set it to HCI only when we do not know about
> > it well.
> > Add support to route to the best controller according to current USB mode
> > (host/peripheral).
> > Note: Currently even if hardware only support hostmode, we should still
> > enable the MUSB controller, as it controls the USB mode. (Some this kind
> > of hardware can also work in peripheral mode by settings in the sysfs
> > node of MUSB, then connect it to another host via a USB Type-A to Type-A
> > cable.)
> > Patch 1 changes the device tree binding to include the "pmu0" for HCI pair.
> > Patch 2 and 3 are fixes for H3 PHY, in order to make MUSB really working
> > on H3.
> > Patch 4 adds support for auto routing of PHY0. It's currently only enabled
> > on H3, but it's easy to extend it to other SoCs which feature this
> > route control.
> merged the 1st four patch of this series.
And applied the last four.
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 801 bytes
Desc: not available
More information about the linux-arm-kernel