[PATCH V2 1/2] ARM: dts: BCM5301X: Specify serial console params in dtsi files

Florian Fainelli f.fainelli at gmail.com
Wed Mar 22 09:49:24 PDT 2017


On 03/15/2017 10:03 AM, Rafał Miłecki wrote:
> From: Rafał Miłecki <rafal at milecki.pl>
> 
> So far every Northstar device we have seen was using the same serial
> console params (115200n8). It probably make the most sense to put it in
> some proper dtsi files instead of repeating over and over for every
> single device. As different boards may use different bootloaders it
> seems the safest idea is to use board specific dtsi files.
> 
> Just in case some vendor decides to use different UART (parameters) this
> can be always easily overwritten.
> 
> Signed-off-by: Rafał Miłecki <rafal at milecki.pl>

Applied, thanks!
-- 
Florian



More information about the linux-arm-kernel mailing list