[PATCH] ARM: dts: Adjust moxart IRQ controller and flags

[Olof Johansson]

On Sat, Mar 18, 2017 at 05:40:01PM +0100, Linus Walleij wrote:
> The moxart interrupt line flags were not respected in previous
> driver: instead of assigning them per-consumer, a fixes mask
> was set in the controller.
> 
> With the migration to a standard Faraday driver we need to
> set up and handle the consumer flags correctly. Also remove
> the Moxart-specific flags when switching to using real consumer
> flags.
> 
> Extend the register window to 0x100 bytes as we may have a few
> more registers in there and it doesn't hurt.
> 
> Tested-by: Jonas Jensen <jonas.jensen at gmail.com>
> Signed-off-by: Jonas Jensen <jonas.jensen at gmail.com>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
> ARM SoC folks: can you please apply this directly to whatever
> DTS branch is applicable for Moxart? We are switching to a
> generic Faraday Technology interrupt controller driver that
> actually make use of the trigger flags so this needs to be
> rectified.

Applied to next/dt, thanks.

-Olof