[PATCH 1/2] irqchip/gic-v3-its: bail out on already enabled LPIs
Marc Zyngier
marc.zyngier at arm.com
Fri Mar 17 02:46:14 PDT 2017
Hi Shanker,
On 16/03/17 17:25, Shanker Donthineni wrote:
> Hi Andre,
>
>
> On 03/16/2017 12:05 PM, Andre Przywara wrote:
>> The GICv3 spec says that once LPIs have been enabled, they can't be
>> disabled anymore:
>> "When a write changes this bit from 0 to 1, this bit becomes RES1 ..."
>> As we can't setup the pending and property table registers when LPIs are
>> enabled, we have to bail out here in this case.
>> But first try to disable LPIs anyway, to check whether this actually works.
>> If not, return an error.
>>
>> Signed-off-by: Andre Przywara <andre.przywara at arm.com>
>> ---
>> drivers/irqchip/irq-gic-v3-its.c | 36 ++++++++++++++++++++++++++++--------
>> 1 file changed, 28 insertions(+), 8 deletions(-)
>>
>> diff --git a/drivers/irqchip/irq-gic-v3-its.c b/drivers/irqchip/irq-gic-v3-its.c
>> index f77f840..b777c57 100644
>> --- a/drivers/irqchip/irq-gic-v3-its.c
>> +++ b/drivers/irqchip/irq-gic-v3-its.c
>> @@ -1082,12 +1082,30 @@ static int its_alloc_collections(struct its_node *its)
>> return 0;
>> }
>>
>> -static void its_cpu_init_lpis(void)
>> +static int its_cpu_init_lpis(void)
>> {
>> void __iomem *rbase = gic_data_rdist_rd_base();
>> struct page *pend_page;
>> u64 val, tmp;
>>
>> + /*
>> + * Architecturally, once LPIs have been enabled on a specific
>> + * redistributor, they can't be disabled anymore (the enable
>> + * bit becomes RES1).
>> + * But as we can't setup the pending and property table registers
>> + * while LPIs are enabled, we are basically screwed in this case.
>> + * But be slightly more optimistic here, and actually check whether
>> + * this is really implemented like this.
>> + */
>> + val = readl_relaxed(rbase + GICR_CTLR);
>> + val &= ~GICR_CTLR_ENABLE_LPIS;
>> + writel_relaxed(val, rbase + GICR_CTLR);
>
> Spec says we are not supposed to disable once it is enabled, why code
> is trying to disable? Why can't we check the enable bit without a
> write operation?
The reasoning here is that some implementation could support having
their LPI disabled (hint: a software implementation like the one we have
in KVM). As much as I'm willing to follow the architecture, I see little
value in not supporting something that trivial. But maybe we could quirk
it and not do that in the general case. Andre, what do you think?
>> + if (readl_relaxed(rbase + GICR_CTLR) & GICR_CTLR_ENABLE_LPIS) {
>> + pr_warn("CPU%d: LPIs already enabled, cannot initialize redistributor\n",
>> + smp_processor_id());
>> + return -EBUSY;
>> + }
>> +
>> /* If we didn't allocate the pending table yet, do it now */
>> pend_page = gic_data_rdist()->pend_page;
>> if (!pend_page) {
>> @@ -1101,7 +1119,7 @@ static void its_cpu_init_lpis(void)
>> if (!pend_page) {
>> pr_err("Failed to allocate PENDBASE for CPU%d\n",
>> smp_processor_id());
>> - return;
>> + return -ENOMEM;
>> }
>>
>> /* Make sure the GIC will observe the zero-ed page */
>> @@ -1113,11 +1131,6 @@ static void its_cpu_init_lpis(void)
>> gic_data_rdist()->pend_page = pend_page;
>> }
>>
>> - /* Disable LPIs */
>> - val = readl_relaxed(rbase + GICR_CTLR);
>> - val &= ~GICR_CTLR_ENABLE_LPIS;
>> - writel_relaxed(val, rbase + GICR_CTLR);
>> -
>> /*
>> * Make sure any change to the table is observable by the GIC.
>> */
>> @@ -1174,6 +1187,8 @@ static void its_cpu_init_lpis(void)
>>
>> /* Make sure the GIC has seen the above */
>> dsb(sy);
>> +
>> + return 0;
>> }
>>
>> static void its_cpu_init_collection(void)
>> @@ -1789,12 +1804,17 @@ static bool gic_rdists_supports_plpis(void)
>>
>> int its_cpu_init(void)
>> {
>> + int ret;
>> +
>> if (!list_empty(&its_nodes)) {
>> if (!gic_rdists_supports_plpis()) {
>> pr_info("CPU%d: LPIs not supported\n", smp_processor_id());
>> return -ENXIO;
>> }
>> - its_cpu_init_lpis();
>> + ret = its_cpu_init_lpis();
>> + if (ret)
>> + return ret;
>
> This is not enough, you have to skip all the disabled collections
> inside the function its_set_affinity() when mapping an event to
> collection. Otherwise all LPIs might mapped to collection 0, causes
> the possibility of memory corruption by GICR hardware on updating
> incorrect PENDING table.
I'm not sure I understand what you mean here.
But in any case, memory corruption may already have happened, and you
have no idea where. In general, finding LPIs being already enabled is
terminally unsafe unless we can key it on a particular implementation.
> I believe better fix would be disable ITS on this condition.
This is certainly an additional fix so that we don't generate additional
traffic, and it would make sure that we don't lure PCI drivers into
using MSIs.
Thanks,
M.
--
Jazz is not dead. It just smells funny...
More information about the linux-arm-kernel
mailing list