[PATCH v4 4/7] arm: set CONFIG_MMC_BCM2835=y in bcm2835_defconfig and multi_v7_defconfig
Ulf Hansson
ulf.hansson at linaro.org
Fri Mar 17 00:35:12 PDT 2017
-trimmed cc list
On 8 March 2017 at 10:19, Gerd Hoffmann <kraxel at redhat.com> wrote:
> We need to enable this controller so that we can switch the SD card's
> pinmux over to it by default, which will improve storage performance.
>
> Read access (dd with 64k blocks on rpi2):
> CONFIG_MMC_SDHCI_IPROC: 11-12 MB/s
> CONFIG_MMC_BCM2835: 19-20 MB/s
>
> Differences on write access are pretty much in the noise.
>
> Signed-off-by: Gerd Hoffmann <kraxel at redhat.com>
Normally this change should go via arm soc. However as the new
CONFIG_MMC_BCM2835 is added in this series, perhaps it makes sense to
that I pick it up. In such case I need an ack from some of the arm soc
folkz, like Arnd/Olof.
Kind regards
Uffe
> ---
> arch/arm/configs/bcm2835_defconfig | 1 +
> arch/arm/configs/multi_v7_defconfig | 1 +
> 2 files changed, 2 insertions(+)
>
> diff --git a/arch/arm/configs/bcm2835_defconfig b/arch/arm/configs/bcm2835_defconfig
> index 4b89f4e..3767c24 100644
> --- a/arch/arm/configs/bcm2835_defconfig
> +++ b/arch/arm/configs/bcm2835_defconfig
> @@ -92,6 +92,7 @@ CONFIG_MMC=y
> CONFIG_MMC_SDHCI=y
> CONFIG_MMC_SDHCI_PLTFM=y
> CONFIG_MMC_SDHCI_IPROC=y
> +CONFIG_MMC_BCM2835=y
> CONFIG_NEW_LEDS=y
> CONFIG_LEDS_CLASS=y
> CONFIG_LEDS_GPIO=y
> diff --git a/arch/arm/configs/multi_v7_defconfig b/arch/arm/configs/multi_v7_defconfig
> index a94126f..63b94d0 100644
> --- a/arch/arm/configs/multi_v7_defconfig
> +++ b/arch/arm/configs/multi_v7_defconfig
> @@ -730,6 +730,7 @@ CONFIG_MMC_DW_EXYNOS=y
> CONFIG_MMC_DW_ROCKCHIP=y
> CONFIG_MMC_SH_MMCIF=y
> CONFIG_MMC_SUNXI=y
> +CONFIG_MMC_BCM2835=y
> CONFIG_NEW_LEDS=y
> CONFIG_LEDS_CLASS=y
> CONFIG_LEDS_CLASS_FLASH=m
> --
> 1.8.3.1
>
More information about the linux-arm-kernel
mailing list