[PATCH 2/2] fpga: Add support for Xilinx LogiCORE PR Decoupler
Moritz Fischer
moritz.fischer.private at gmail.com
Mon Mar 13 09:18:31 PDT 2017
On Mon, Mar 13, 2017 at 3:27 AM, Michal Simek <michal.simek at xilinx.com> wrote:
> Hi Moritz,
>
> On 10.3.2017 23:42, Moritz Fischer wrote:
>> On Fri, Mar 10, 2017 at 1:30 PM, Moritz Fischer <mdf at kernel.org> wrote:
>>> This adds support for the Xilinx LogiCORE PR Decoupler
>>> soft-ip that does decoupling of PR regions in the FPGA
>>> fabric during partial reconfiguration.
>>>
>>> Signed-off-by: Moritz Fischer <mdf at kernel.org>
>>> Cc: Michal Simek <michal.simek at xilinx.com>
>>> Cc: Sören Brinkmann <soren.brinkmann at xilinx.com>
>>> Cc: linux-kernel at vger.kernel.org
>>> Cc: devicetree at vger.kernel.org
>>> ---
>>> drivers/fpga/Kconfig | 9 +++
>>> drivers/fpga/Makefile | 1 +
>>> drivers/fpga/xilinx-pr-decoupler.c | 156 +++++++++++++++++++++++++++++++++++++
>>> 3 files changed, 166 insertions(+)
>>> create mode 100644 drivers/fpga/xilinx-pr-decoupler.c
>
> I have written very similar driver some week ago but didn't sent it out.
Hah. I'll take a look.
> Here it is.
> https://github.com/Xilinx/linux-xlnx/blob/master/drivers/fpga/xilinx-pr-decoupler.c
>
> Your clk handling is better and my enable_show is better.
> You shouldn't rely on setting status before. It is better to read that
> reg again. The reason is you can connect status signal from one PR
> decoupler to decouple input which can change status
I will just merge them together and add you to author's list if that's
fine with you?
> There is another topic I wanted to open in connection to this. There
> should be gpio based bridge because this pr decoupler can be without axi
> interface and for that gpio driver would be useful.
That's a good idea. I can look at that. This can be pretty generic
code I suppose.
Cheers,
Moritz
More information about the linux-arm-kernel
mailing list