[PATCH 1/2] usb: xhci-mtk: check hcc_params after adding primary hcd
Chunfeng Yun
chunfeng.yun at mediatek.com
Mon Mar 6 19:32:22 PST 2017
hcc_params is set in xhci_gen_setup() called from usb_add_hcd(),
so checks the Maximum Primary Stream Array Size in the hcc_params
register after adding primary hcd.
Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
---
drivers/usb/host/xhci-mtk.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/host/xhci-mtk.c b/drivers/usb/host/xhci-mtk.c
index 9066ec9..6ac73a6 100644
--- a/drivers/usb/host/xhci-mtk.c
+++ b/drivers/usb/host/xhci-mtk.c
@@ -678,13 +678,13 @@ static int xhci_mtk_probe(struct platform_device *pdev)
goto power_off_phys;
}
- if (HCC_MAX_PSA(xhci->hcc_params) >= 4)
- xhci->shared_hcd->can_do_streams = 1;
-
ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
if (ret)
goto put_usb3_hcd;
+ if (HCC_MAX_PSA(xhci->hcc_params) >= 4)
+ xhci->shared_hcd->can_do_streams = 1;
+
ret = usb_add_hcd(xhci->shared_hcd, irq, IRQF_SHARED);
if (ret)
goto dealloc_usb2_hcd;
--
1.7.9.5
More information about the linux-arm-kernel
mailing list