[PATCH] Documentation: dt: Add binding for /chosen/secure-stdout-path

[Jerome Forissier]

Some platforms may use a single device tree to describe two address
spaces, as described in d9f43babb998 ("Documentation: dt: Add bindings
for Secure-only devices"). We extend the use of the secure- prefix to
the stdout-path property, so that the Secure firmware may use a
different console device than the one used by the kernel.

Signed-off-by: Jerome Forissier <jerome.forissier at linaro.org>
---
 Documentation/devicetree/bindings/arm/secure.txt | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/arm/secure.txt b/Documentation/devicetree/bindings/arm/secure.txt
index e31303f..558c9a1 100644
--- a/Documentation/devicetree/bindings/arm/secure.txt
+++ b/Documentation/devicetree/bindings/arm/secure.txt
@@ -51,3 +51,8 @@ Valid Secure world properties:
    status = "disabled"; secure-status = "okay";     /* S-only */
    status = "disabled";                             /* disabled in both */
    status = "disabled"; secure-status = "disabled"; /* disabled in both */
+
+- secure-stdout-path (/chosen node): specifies the device to be used
+for console output by Secure firmware. The syntax is the same as for
+"stdout-path". If "secure-stdout-path" is not specified it defaults to
+the same value as "stdout-path".
-- 
2.7.4