[RFC 0/5] drivers: Add boot constraints core

Viresh Kumar viresh.kumar at linaro.org
Thu Jun 29 22:12:03 PDT 2017


On 30-06-17, 12:22, Chen-Yu Tsai wrote:
> On Fri, Jun 30, 2017 at 12:12 PM, Viresh Kumar <viresh.kumar at linaro.org> wrote:
> > On 30-06-17, 12:05, Chen-Yu Tsai wrote:

> >> I also want to mention that for DT based platforms, this constraint
> >> should already be set in the device tree for the regulator, so the
> >> scenario where DMA comes up and sets a voltage level that LCD cannot
> >> use should not even be possible.
> 
> What I'm saying is for the DT case, the constraints are already limited
> to the intersection of all users, regardless of whether they are turned
> on or not.

Right, but someone needs to get the regulator first to have that
considered by the regulator core while deciding the final range.

Both DMA and LCD driver do regulator_get() for their devices but if
only DMA driver is probed until now, then the regulator core wouldn't
consider LCD as regulator_get() is never called for LCD.

> I think what you mean is that the DT constraints are the union of all
> consumer constraints (1.8 - 3.0 V in this case), then each consumer
> comes in and adds its own constraints. And for such a design, the kernel
> needs to know which and what constraints to apply.

Sorry, I am confused with what you just said and not sure if I
understand it completely.

Each consumer DT node will have its own set of constraints for the
regulator device. The kernel will do regulator_get() for them one by
one, based on when their drivers get probed. And an intersection of
those constraints (which already did regulator_get()) will be used by
the regulator core.

Now this series is saying that even if the driver didn't come up (for
LCD) and haven't done its regulator_get() yet, consider that device's
constraint while calculating the target voltage for the regulator.

> Either way regulators already support constraints, so they are easier
> to deal with. Clocks on the other hand, while the core does support
> clock rate constraints, AFAIK no one really uses or supports them.

Yeah, so I started with just regulators and that's when Mark suggested
to do something generic which can be reused by other resource types.
We may end up covering clk for sure I believe. Not sure yet about
other resource types though.

-- 
viresh



More information about the linux-arm-kernel mailing list