[PATCH v3 0/9] Add and make use of a common rs485 device tree parsing function

[Uwe Kleine-König]

Hello Greg,

On Thu, Jun 29, 2017 at 05:12:00PM +0200, Greg KH wrote:
> On Mon, Jun 26, 2017 at 11:07:54AM +0200, Uwe Kleine-König wrote:
> > this is v3 of the series that targets to consolidate parsing the rs485 specific
> > dt properties in a single place.
> 
> This patch breaks the build, and not all of them applied properly :(

sigh :( Sorry for the build breaker.

Regarding "doesn't apply": I tested to rebase on next/master (and so
tty-next) and it applies there just fine. I considered that good enough.
I guess you're talking about tty-testing?! I suggest to mention the
branch name you want to apply patches on in such mails.

There is a patch you applied on tty-testing that is not ok I think
("serial: imx-serial - move DMA buffer configuration to DT"). I
commented this one in the respective thread now.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |