cpufreq: frequency scaling spec in DT node

[Viresh Kumar]

On 29-06-17, 15:01, Mason wrote:
> On 29/06/2017 13:41, Mason wrote:
> 
> > On 29/06/2017 12:04, Viresh Kumar wrote:
> > 
> >> There is one thing you can do to avoid adding OPP entries in the DT.
> >> You can rather add them dynamically with help of: dev_pm_opp_add() and
> >> cpufreq-dt will continue to work with that too.
> > 
> > In what driver should I call these... the clk driver?
> > (drivers/clk/tegra/cvb.c seems to be doind that)
> 
> The problem I run into is that calling get_cpu_device(0) from the
> clk driver returns NULL, because topology_init() has not run yet
> (to initialize the cpu_sys_devices).
> 
> So the OPP table needs to be built *after* topology_init() but
> *before* dt_cpufreq_probe().
> 
> subsys_initcall(topology_init);
> device_initcall(cpufreq_dt_platdev_init);
> 
> I'm not sure how to proceed.

As we discussed over IRC, you can control the creation of cpufreq-dt
platform device and hence when the cpufreq-dt driver gets probed. Your
own cpufreq driver is the way to go here.

-- 
viresh