[PATCH v2 0/2] add UniPhier thermal support
Kunihiko Hayashi
hayashi.kunihiko at socionext.com
Wed Jun 28 03:11:57 PDT 2017
This series adds support for CPU temperature monitor modules implemented
on UniPhier LD20 and PXs2 SoCs. This driver supports temperature monitoring
and alert function on the module.
Changes in v1:
- separate dts from this patchset as another patchset
- remove 'reg' description on the dt-bindings document
- fix the order of calling initialization functions
- replace mask bits to use GENMASK
- fix calculation of temperature because of not considering a negative value
- use devm_request_threaded_irq() instead of devm_request_irq() and
separate a thread function from the interrupt handler
- add dependency to Kconfig
- set 120C to CRITICAL_TEMP_LIMIT as maximum temperature
- shrink each line of parameters to save the number of lines
- improve some comments and copyright description
Kunihiko Hayashi (2):
dt-bindings: thermal: add binding documentation for UniPhier thermal
monitor
thermal: uniphier: add UniPhier thermal driver
.../bindings/thermal/uniphier-thermal.txt | 64 ++++
drivers/thermal/Kconfig | 8 +
drivers/thermal/Makefile | 1 +
drivers/thermal/uniphier_thermal.c | 391 +++++++++++++++++++++
4 files changed, 464 insertions(+)
create mode 100644 Documentation/devicetree/bindings/thermal/uniphier-thermal.txt
create mode 100644 drivers/thermal/uniphier_thermal.c
--
2.7.4
More information about the linux-arm-kernel
mailing list