[PATCH linux-next v4 2/4] spi: imx: add selection for iMX53 and iMX6 controller

Jiada Wang jiada_wang at mentor.com
Mon Jun 26 18:25:52 PDT 2017


Hello Mark and Sascha

Could you please review my v4 patch set for i.MX SPI slave support

Thanks,
Jiada

On 06/13/2017 07:29 AM, Rob Herring wrote:
> On Tue, Jun 13, 2017 at 12:28 AM, Jiada Wang<jiada_wang at mentor.com>  wrote:
>> Hello Rob
>>
>>
>> On 06/13/2017 12:53 AM, Rob Herring wrote:
>>> On Thu, Jun 08, 2017 at 02:16:01PM +0900, Jiada Wang wrote:
>>>> ECSPI contorller for iMX53 and iMX6 has few hardware issues
>>>> comparing to iMX51.
>>>> The change add possibility to detect which controller is used
>>>> to apply possible workaround and limitations.
>>>>
>>>> Signed-off-by: Jiada Wang<jiada_wang at mentor.com>
>>>> ---
>>>>   .../devicetree/bindings/spi/fsl-imx-cspi.txt       |  1 +
>>>>   drivers/spi/spi-imx.c                              | 26
>>>> ++++++++++++++++++++--
>>>>   2 files changed, 25 insertions(+), 2 deletions(-)
>>>>
>>>> diff --git a/Documentation/devicetree/bindings/spi/fsl-imx-cspi.txt
>>>> b/Documentation/devicetree/bindings/spi/fsl-imx-cspi.txt
>>>> index 31b5b21..5bf1396 100644
>>>> --- a/Documentation/devicetree/bindings/spi/fsl-imx-cspi.txt
>>>> +++ b/Documentation/devicetree/bindings/spi/fsl-imx-cspi.txt
>>>> @@ -9,6 +9,7 @@ Required properties:
>>>>     - "fsl,imx31-cspi" for SPI compatible with the one integrated on
>>>> i.MX31
>>>>     - "fsl,imx35-cspi" for SPI compatible with the one integrated on
>>>> i.MX35
>>>>     - "fsl,imx51-ecspi" for SPI compatible with the one integrated on
>>>> i.MX51
>>>> +  - "fsl,imx53-ecspi" for SPI compatible with the one integrated on
>>>> i.MX53 and later Soc
>>>>   - reg : Offset and length of the register set for the device
>>>>   - interrupts : Should contain CSPI/eCSPI interrupt
>>>>   - cs-gpios : Specifies the gpio pins to be used for chipselects.
>>>> diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
>>>> index 4469121..8e6f339 100644
>>>> --- a/drivers/spi/spi-imx.c
>>>> +++ b/drivers/spi/spi-imx.c
>>>> @@ -63,7 +63,8 @@ enum spi_imx_devtype {
>>>>          IMX27_CSPI,
>>>>          IMX31_CSPI,
>>>>          IMX35_CSPI,     /* CSPI on all i.mx except above */
>>>> -       IMX51_ECSPI,    /* ECSPI on i.mx51 and later */
>>>> +       IMX51_ECSPI,    /* ECSPI on i.mx51 */
>>>> +       IMX53_ECSPI,    /* ECSPI on i.mx53 and later */
>>>
>>> Looks like i.MX51 and i.MX53 are the same. While the DT should have
>>> different compatibles (with fallbacks), the driver should map them to
>>> the same type until there's some difference found.
>>>
>> the difference between i.MX51 and i.MX53 is introduced in the
>> 4th patch "spi: imx: Add support for SPI Slave mode" in this patch set
> Okay, I missed that.
>
>> do you think, I need to merge the two patches into one?
> No, not necessary.
>
> Acked-by: Rob Herring<robh at kernel.org>
>
> Rob




More information about the linux-arm-kernel mailing list