[PATCH v2 4/9] serial: atmel: Use common rs485 device tree parsing function

[Richard Genoud]

2017-06-23 11:49 GMT+02:00 Uwe Kleine-König <u.kleine-koenig at pengutronix.de>:
> From: Sascha Hauer <s.hauer at pengutronix.de>
>
> We just got a common helper for parsing the rs485 specific
> device tree properties. Use it and drop the open coded parser.
>
> Note that there is a small difference between the removed and the now
> used implementation: The former cleared flags to 0 if rs485-rts-delay
> was given, the common helper clears SER_RS485_RX_DURING_TX and
> SER_RS485_ENABLED only but always which makes more sense.
>
> Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> [ukleinek: point out semantic change in commit log]
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig at pengutronix.de>
> ---
> Changes since v1:
>  - as I dropped my two atmel patches and used Alexandre Belloni's (that are
>    already in next) instead, there are a few changes that are necessary to
>    adapt to the new base.
>
>  drivers/tty/serial/atmel_serial.c | 17 +----------------
>  1 file changed, 1 insertion(+), 16 deletions(-)
>
> diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
> index 937d67f22fba..357570a216ad 100644
> --- a/drivers/tty/serial/atmel_serial.c
> +++ b/drivers/tty/serial/atmel_serial.c
> @@ -1689,22 +1689,7 @@ static void atmel_init_rs485(struct uart_port *port,
>  {
>         struct device_node *np = pdev->dev.of_node;
>
> -       struct serial_rs485 *rs485conf = &port->rs485;
> -       u32 rs485_delay[2];
> -
> -       /* rs485 properties */
> -       if (of_property_read_u32_array(np, "rs485-rts-delay",
> -                                      rs485_delay, 2) == 0) {
> -               rs485conf->delay_rts_before_send = rs485_delay[0];
> -               rs485conf->delay_rts_after_send = rs485_delay[1];
> -               rs485conf->flags = 0;
> -       }
> -
> -       if (of_get_property(np, "rs485-rx-during-tx", NULL))
> -               rs485conf->flags |= SER_RS485_RX_DURING_TX;
> -
> -       if (of_get_property(np, "linux,rs485-enabled-at-boot-time", NULL))
> -               rs485conf->flags |= SER_RS485_ENABLED;
> +       of_get_rs485_mode(np, &port->rs485);
>  }

as atmel_init_rs485() is only used once in the code, what do you think of
getting rid of it and just have something like:
of_get_rs485_mode(pdev->dev.of_node, &port->rs485);
in atmel_init_port() ?
(possibly with a little comment)

regards,
Richard.
>
>  static void atmel_set_ops(struct uart_port *port)
> --
> 2.11.0
>