[PATCH V4 7/7] pinctrl: pinctrl-imx7ulp: add gpio_set_direction support
Dong Aisheng
aisheng.dong at nxp.com
Wed Jun 21 04:59:55 PDT 2017
Add gpio_set_direction support. This makes the driver support
GPIO input/output dynamically change from userspace.
Cc: Linus Walleij <linus.walleij at linaro.org>
Cc: Alexandre Courbot <gnurou at gmail.com>
Cc: Shawn Guo <shawnguo at kernel.org>
Cc: Stefan Agner <stefan at agner.ch>
Cc: Fugang Duan <fugang.duan at nxp.com>
Cc: Bai Ping <ping.bai at nxp.com>
Signed-off-by: Dong Aisheng <aisheng.dong at nxp.com>
---
ChangeLog:
* New patch. Derived from the original:
[PATCH 1/2] pinctrl: pinctrl-imx: add IBE and OBE SoC property
---
drivers/pinctrl/freescale/pinctrl-imx7ulp.c | 26 ++++++++++++++++++++++++++
1 file changed, 26 insertions(+)
diff --git a/drivers/pinctrl/freescale/pinctrl-imx7ulp.c b/drivers/pinctrl/freescale/pinctrl-imx7ulp.c
index 96127dc..b7bebb2 100644
--- a/drivers/pinctrl/freescale/pinctrl-imx7ulp.c
+++ b/drivers/pinctrl/freescale/pinctrl-imx7ulp.c
@@ -259,6 +259,8 @@ static const struct pinctrl_pin_desc imx7ulp_pinctrl_pads[] = {
IMX_PINCTRL_PIN(IMX7ULP_PAD_PTF19),
};
+#define BM_OBE_ENABLED BIT(17)
+#define BM_IBE_ENABLED BIT(16)
#define BM_LK_ENABLED BIT(15)
#define BM_MUX_MODE 0xf00
#define BP_MUX_MODE 8
@@ -300,10 +302,34 @@ static void imx7ulp_cfg_params_fixup(unsigned long *configs,
}
}
+static int imx7ulp_pmx_gpio_set_direction(struct pinctrl_dev *pctldev,
+ struct pinctrl_gpio_range *range,
+ unsigned offset, bool input)
+{
+ struct imx_pinctrl *ipctl = pinctrl_dev_get_drvdata(pctldev);
+ struct imx_pinctrl_soc_info *info = ipctl->info;
+ const struct imx_pin_reg *pin_reg;
+ u32 reg;
+
+ pin_reg = &info->pin_regs[offset];
+ if (pin_reg->mux_reg == -1)
+ return -EINVAL;
+
+ reg = readl(ipctl->base + pin_reg->mux_reg);
+ if (input)
+ reg = (reg & ~BM_OBE_ENABLED) | BM_IBE_ENABLED;
+ else
+ reg = (reg & ~BM_IBE_ENABLED) | BM_OBE_ENABLED;
+ writel(reg, ipctl->base + pin_reg->mux_reg);
+
+ return 0;
+}
+
static struct imx_pinctrl_soc_info imx7ulp_pinctrl_info = {
.pins = imx7ulp_pinctrl_pads,
.npins = ARRAY_SIZE(imx7ulp_pinctrl_pads),
.flags = ZERO_OFFSET_VALID | SHARE_MUX_CONF_REG,
+ .gpio_set_direction = imx7ulp_pmx_gpio_set_direction,
.mux_mask = BM_MUX_MODE,
.mux_shift = BP_MUX_MODE,
.generic_pinconf = true,
--
2.7.4
More information about the linux-arm-kernel
mailing list