[PATCH v3 0/4] Generalize fncpy availability

[Florian Fainelli]

On 06/20/2017 09:54 AM, Sudeep Holla wrote:
> 
> 
> On 20/06/17 17:20, Florian Fainelli wrote:
>> On 06/20/2017 02:10 AM, Lorenzo Pieralisi wrote:
>>> [+Sudeep]
>>>
>>> On Mon, Jun 19, 2017 at 10:32:38AM -0700, Florian Fainelli wrote:
>>>> On 06/19/2017 05:24 AM, Mark Rutland wrote:
>>>>> On Fri, Jun 16, 2017 at 05:07:40PM -0700, Florian Fainelli wrote:
>>>>>> Hi all,
>>>>>
>>>>> Hi Florian,
>>>>>
>>>>>> This patch series makes ARM's fncpy() implementation more generic (dropping the
>>>>>> Thumb-specifics) and available in an asm-generic header file.
>>>>>>
>>>>>> Tested on a Broadcom ARM64 STB platform with code that is written to SRAM.
>>>>>>
>>>>>> Changes in v3 (thanks Doug!):
>>>>>> - correct include guard names in asm-generic/fncpy.h to __ASM_FNCPY_H
>>>>>> - utilize Kbuild to provide the fncpy.h header on ARM64
>>>>>>
>>>>>> Changes in v2:
>>>>>> - leave the ARM implementation where it is
>>>>>> - make the generic truly generic (no)
>>>>>>
>>>>>> This is helpful in making SoC-specific power management code become true drivers
>>>>>> that can be shared between different architectures.
>>>>>> Could you elaborate on what this is needed for?
>>>>
>>>> Several uses cases come to mind:
>>>>
>>>> - it could be used as a trampoline code prior to entering S2 for systems
>>>> that do not support PSCI 1.0
>>>
>>> I think S2 here means PM_SUSPEND_MEM. It is very wrong to manage power
>>> states through platform specific hooks on PSCI based systems, consider
>>> upgrading to PSCI 1.0 please (or implement PSCI CPU_SUSPEND power
>>> states that allow to achieve same power savings as PM_SUSPEND_MEM
>>> by just entering suspend-to-idle).
>>
>> S2 is PM_SUSPEND_STANDBY and S3 is PM_SUSPEND_MEM, at least that how I
>> read it. I would rather we update to PSCI 1.0 (at least) to properly
>> support SYSTEM_SUSPEND rather than retrofitting a system-wide suspend
>> state into CPU_SUSPEND since that seems wrong.
>>
> 
> This has been discussed multiple times in the past. No one has come back
> with strong reason to add that to the PSCI SYSTEM_SUSPEND API.
> 
> Care to explain the difference between PM_SUSPEND_STANDBY and S3 is
> PM_SUSPEND_MEM on your platform. And why it can't be achieved with
> suspend-to-idle ?

S2 preserves the ON/OFF island power and allows wake logic to wake the
system (infrared, GPIOs, Wake-on-LAN/WLAN, etc.) whereas S3 allows
powering off the ON/OFF island entirely, and allows for a lower power
consumption, with a subset of the wake peripherals to actually wake the
system. S5 is also implemented although its use case is narrower (soft-off).

The higher latency involved in S3 entry/exit is totally accepted due to
the higher power savings that it yields.

> 
> You can always report any issue with PSCI specification at
> errata at arm.com as mentioned in the document.

I just did because there are a few other things missing.
-- 
Florian