[PATCH v2 1/2] dt/bindings: Add bindings for Broadcom STB DRAM Sensors

[Markus Mayer]

On 18 June 2017 at 07:05, Rob Herring <robh at kernel.org> wrote:
> On Tue, Jun 13, 2017 at 03:37:09PM -0700, Markus Mayer wrote:
>> From: Markus Mayer <mmayer at broadcom.com>
>>
>> Provide bindings for the Broadcom STB DDR PHY Front End (DPFE).
>>
>> Signed-off-by: Markus Mayer <mmayer at broadcom.com>
>> ---
>>  .../devicetree/bindings/soc/bcm/brcm,dpfe-cpu.txt  | 27 ++++++++++++++++++++++
>>  1 file changed, 27 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/soc/bcm/brcm,dpfe-cpu.txt
>
> Acked-by: Rob Herring <robh at kernel.org>

Thanks, Rob.

To bring up the previous discussion regarding enumerating multiple
nodes (so far we need two dpfe nodes for some platforms), how should
we go about this? We were originally proposing to use "cell-index",
but you said this was OpenFirmware only and couldn't be used in device
tree. See https://lkml.org/lkml/2017/4/27/574.

We do need to use something, because the driver needs to know if it
should be accessing dpfe0 or dpfe1. What should we use?

Thanks,
-Markus