[PATCH 1/3] clk: meson: meson8b: add compatibles for Meson8 and Meson8m2

[Kevin Hilman]

Jerome Brunet <jbrunet at baylibre.com> writes:

> On Sun, 2017-06-04 at 20:33 +0200, Martin Blumenstingl wrote:
>> The clock controller on Meson8, Meson8b and Meson8m2 is very similar
>> based on the code from the Amlogic GPL kernel sources. Add separate
>> compatibles for each SoC to make sure that we can easily implement
>> all the small differences for each SoC later on.
>> 
>> In general the Meson8 and Meson8m2 seem to be almost identical as they
>> even share the same mach-meson8 directory in Amlogic's GPL kernel
>> sources.
>> The main clocks on Meson8, Meson8b and Meson8m2 are very similar,
>> because they are all using the same PLL values, 90% of the clock gates
>> are the same (the actual diffstat of the mach-meson8/clock.c and
>> mach-meson8b/clock.c files is around 30 to 40 lines, when excluding
>> all commented out code).
>> The difference between the Meson8 and Meson8b clock gates seem to be:
>> - Meson8 has AIU_PCLK, HDMI_RX, VCLK2_ENCT, VCLK2_ENCL, UART3,
>>   CSI_DIG_CLKIN gates which don't seem to be available on Meson8b
>> - the gate on Meson8 for bit 7 seems to be named "_1200XXX" instead
>>   of "PERIPHS_TOP" (on Meson8b)
>> - Meson8b has a SANA gate which doesn't seem to exist on Meson8 (or
>>   on Meson8 the same bit is used by the UART3 gate in Amlogic's GPL
>>   kernel sources)
>> None of these gates is added for now, since it's unclear whether these
>> definitions are actually correct (the VCLK2_ENCT gate for example is
>> defined, but only used in some commented block).
>> 
>> The main difference between all three SoCs seem to be the video (VPU)
>> clocks. Apart from different supported clock rates (according to vpu.c
>> in mach-meson8 and mach-meson8b from Amlogic's GPL kernel sources) the
>> most notable difference is that Meson8m2 has a GP_PLL clock and a mux
>> (probably the same as on the Meson GX SoCs) to support glitch-free
>> (clock rate) switching.
>> None of these VPU clocks are not supported by our mainline meson8b
>> clock driver yet though.
>> 
>> Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
>> ---
>>  .../devicetree/bindings/clock/amlogic,meson8b-clkc.txt        | 11 +++++++---
>
> I think you should split the binding documentation and clk changes into separate
> patches.
>
>> -
>>  drivers/clk/meson/Kconfig                                     |  6 +++---
>>  drivers/clk/meson/meson8b.c                                   |  5 ++++-
>
> The change being more platform than clock related, I'd prefer if Kevin or Carlo
> ack it before we apply it.

Acked-by: Kevin Hilman <khilman at baylibre.com>