[PATCH 1/3] dt-bindings: Add support for samsung s6e63j0x03 panel binding

[Hoegeun Kwon]

The Samsung s6e63j0x03 is a 1.63" 320x320 AMOLED panel connected using
MIPI-DSI interfaces.

Signed-off-by: Hoegeun Kwon <hoegeun.kwon at samsung.com>
---
 .../bindings/display/panel/samsung,s6e63j0x03.txt  | 24 ++++++++++++++++++++++
 1 file changed, 24 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt

diff --git a/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt b/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt
new file mode 100644
index 0000000..34b6e2a
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/panel/samsung,s6e63j0x03.txt
@@ -0,0 +1,24 @@
+Samsung S6E63J0X03 1.63" 320x320 AMOLED panel
+
+Required properties:
+  - compatible: "samsung,s6e63j0x03"
+  - reg: the virtual channel number of a DSI peripheral
+  - vdd3-supply: I/O voltage supply
+  - vci-supply: voltage supply for analog circuits
+  - reset-gpios: a GPIO spec for the reset pin (active high)
+  - te-gpios: a GPIO spec for the tearing effect synchronization signal
+    gpio pin (active high)
+
+Example:
+&dsi {
+	...
+
+	panel at 0 {
+		compatible = "samsung,s6e63j0x03";
+		reg = <0>;
+		vdd3-supply = <&ldo16_reg>;
+		vci-supply = <&ldo20_reg>;
+		reset-gpios = <&gpe0 1 GPIO_ACTIVE_HIGH>;
+		te-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
+	};
+};
-- 
1.9.1