[PATCH] net/{mii,smsc}: Make mii_ethtool_get_link_ksettings and smc_netdev_get_ecmd return void

[Yuval Shaia]

On Sun, Jun 04, 2017 at 09:01:33PM +0200, Andrew Lunn wrote:
> > diff --git a/drivers/net/cris/eth_v10.c b/drivers/net/cris/eth_v10.c
> > index da02041..017f48c 100644
> > --- a/drivers/net/cris/eth_v10.c
> > +++ b/drivers/net/cris/eth_v10.c
> > @@ -1417,10 +1417,9 @@ static int e100_get_link_ksettings(struct net_device *dev,
> >  {
> >  	struct net_local *np = netdev_priv(dev);
> >  	u32 supported;
> > -	int err;
> >  
> >  	spin_lock_irq(&np->lock);
> > -	err = mii_ethtool_get_link_ksettings(&np->mii_if, cmd);
> > +	mii_ethtool_get_link_ksettings(&np->mii_if, cmd);
> >  	spin_unlock_irq(&np->lock);
> >  
> >  	/* The PHY may support 1000baseT, but the Etrax100 does not.  */
> > @@ -1432,7 +1431,7 @@ static int e100_get_link_ksettings(struct net_device *dev,
> >  	ethtool_convert_legacy_u32_to_link_mode(cmd->link_modes.supported,
> >  						supported);
> >  
> > -	return err;
> > +	return 0;
> >  }
> 
> How far are going planning on going? It seems like
> *_get_link_ksettings() now all return a useless 0. Do you plan to
> change ethtool_ops and make if void all the way up?

It is not always correct, see for example how xgene_get_link_ksettings
returns non-zero value so i assume that ethtool_ops should remain as it is.
Also, looking at ethtool_get_settings it seems that returned value is
checked.

> 
>        Andrew