[PATCH v6 2/3] phy:phy-bcm-ns2-usbdrd:Broadcom USB DRD Phy driver for Northstar2
Raviteja Garimella
raviteja.garimella at broadcom.com
Fri Jun 2 05:06:56 PDT 2017
Hi,
On Fri, Jun 2, 2017 at 5:26 PM, Kishon Vijay Abraham I <kishon at ti.com> wrote:
> Hi,
>
> On Friday 02 June 2017 05:21 PM, Raviteja Garimella wrote:
>> Hi,
>>
>> On Fri, Jun 2, 2017 at 5:18 PM, Raviteja Garimella
>> <raviteja.garimella at broadcom.com> wrote:
>>> Hi Kishon,
>>>
>>> On Fri, Jun 2, 2017 at 3:59 PM, Kishon Vijay Abraham I <kishon at ti.com> wrote:
>>>> Hi,
>>>>
>>>> On Wednesday 31 May 2017 03:42 PM, Raviteja Garimella wrote:
>>>>> This is driver for USB DRD Phy used in Broadcom's Northstar2
>>>>> SoC. The phy can be configured to be in Device mode or Host
>>>>> mode based on the type of cable connected to the port. The
>>>>> driver registers to extcon framework to get appropriate
>>>>> connect events for Host/Device cables connect/disconnect
>>>>> states based on VBUS and ID interrupts.
>>>>>
>>>>> Signed-off-by: Raviteja Garimella <raviteja.garimella at broadcom.com>
>>>>> ---
>>>>> drivers/phy/Kconfig | 13 ++
>>>>> drivers/phy/Makefile | 1 +
>>>>> drivers/phy/phy-bcm-ns2-usbdrd.c | 466 +++++++++++++++++++++++++++++++++++++++
>>>>> 3 files changed, 480 insertions(+)
>>>>> create mode 100644 drivers/phy/phy-bcm-ns2-usbdrd.c
>>>>>
>>>>> diff --git a/drivers/phy/Kconfig b/drivers/phy/Kconfig
>>>>> index afaf7b6..8028da7 100644
>>>>> --- a/drivers/phy/Kconfig
>>>>> +++ b/drivers/phy/Kconfig
>>>>> @@ -507,6 +507,19 @@ config PHY_CYGNUS_PCIE
>>>>> Enable this to support the Broadcom Cygnus PCIe PHY.
>>>>> If unsure, say N.
>>>>>
>>>>> +config PHY_NS2_USB_DRD
>>>>> + tristate "Broadcom Northstar2 USB DRD PHY support"
>>>>> + depends on OF && (ARCH_BCM_IPROC || COMPILE_TEST)
>>>>> + select GENERIC_PHY
>>>>> + select EXTCON
>>>>> + default ARCH_BCM_IPROC
>>>>> + help
>>>>> + Enable this to support the Broadcom Northstar2 USB DRD PHY.
>>>>> + This driver initializes the PHY in either HOST or DEVICE mode.
>>>>> + The host or device configuration is read from device tree.
>>>>> +
>>>>> + If unsure, say N.
>>>>> +
>>>>> source "drivers/phy/tegra/Kconfig"
>>>>>
>>>>> config PHY_NS2_PCIE
>>>>> diff --git a/drivers/phy/Makefile b/drivers/phy/Makefile
>>>>> index f8047b4..e5fbb0e 100644
>>>>> --- a/drivers/phy/Makefile
>>>>> +++ b/drivers/phy/Makefile
>>>>> @@ -61,6 +61,7 @@ obj-$(CONFIG_PHY_TUSB1210) += phy-tusb1210.o
>>>>> obj-$(CONFIG_PHY_BRCM_SATA) += phy-brcm-sata.o
>>>>> obj-$(CONFIG_PHY_PISTACHIO_USB) += phy-pistachio-usb.o
>>>>> obj-$(CONFIG_PHY_CYGNUS_PCIE) += phy-bcm-cygnus-pcie.o
>>>>> +obj-$(CONFIG_PHY_NS2_USB_DRD) += phy-bcm-ns2-usbdrd.o
>>>>> obj-$(CONFIG_ARCH_TEGRA) += tegra/
>>>>> obj-$(CONFIG_PHY_NS2_PCIE) += phy-bcm-ns2-pcie.o
>>>>> obj-$(CONFIG_PHY_MESON8B_USB2) += phy-meson8b-usb2.o
>>>>> diff --git a/drivers/phy/phy-bcm-ns2-usbdrd.c b/drivers/phy/phy-bcm-ns2-usbdrd.c
>>>>> new file mode 100644
>>>>> index 0000000..8e05c70
>>>>> --- /dev/null
>>>>> +++ b/drivers/phy/phy-bcm-ns2-usbdrd.c
>>>>> @@ -0,0 +1,466 @@
>>>>> +/*
>>>>> + * Copyright (C) 2017 Broadcom
>>>>> + *
>>>>> + * This program is free software; you can redistribute it and/or
>>>>> + * modify it under the terms of the GNU General Public License as
>>>>> + * published by the Free Software Foundation version 2.
>>>>> + *
>>>>> + * This program is distributed "as is" WITHOUT ANY WARRANTY of any
>>>>> + * kind, whether express or implied; without even the implied warranty
>>>>> + * of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
>>>>> + * GNU General Public License for more details.
>>>>> + */
>>>>> +
>>>>> +#include <linux/delay.h>
>>>>> +#include <linux/extcon.h>
>>>>> +#include <linux/gpio.h>
>>>>> +#include <linux/gpio/consumer.h>
>>>>> +#include <linux/init.h>
>>>>> +#include <linux/interrupt.h>
>>>>> +#include <linux/io.h>
>>>>> +#include <linux/irq.h>
>>>>> +#include <linux/mfd/syscon.h>
>>>>> +#include <linux/module.h>
>>>>> +#include <linux/of.h>
>>>>> +#include <linux/of_address.h>
>>>>> +#include <linux/phy/phy.h>
>>>>> +#include <linux/platform_device.h>
>>>>> +#include <linux/regmap.h>
>>>>> +#include <linux/slab.h>
>>>>> +#include <linux/workqueue.h>
>>>>> +
>>>>> +#define ICFG_DRD_AFE 0x0
>>>>> +#define ICFG_MISC_STAT 0x18
>>>>> +#define ICFG_DRD_P0CTL 0x1C
>>>>> +#define ICFG_STRAP_CTRL 0x20
>>>>> +#define ICFG_FSM_CTRL 0x24
>>>>> +
>>>>> +#define ICFG_DEV_BIT BIT(2)
>>>>> +#define IDM_RST_BIT BIT(0)
>>>>> +#define AFE_CORERDY_VDDC BIT(18)
>>>>> +#define PHY_PLL_RESETB BIT(15)
>>>>> +#define PHY_RESETB BIT(14)
>>>>> +#define PHY_PLL_LOCK BIT(0)
>>>>> +
>>>>> +#define DRD_DEV_MODE BIT(20)
>>>>> +#define OHCI_OVRCUR_POL BIT(11)
>>>>> +#define ICFG_OFF_MODE BIT(6)
>>>>> +#define PLL_LOCK_RETRY 1000
>>>>> +
>>>>> +#define EVT_DEVICE 0
>>>>> +#define EVT_HOST 1
>>>>> +
>>>>> +#define DRD_HOST_MODE (BIT(2) | BIT(3))
>>>>> +#define DRD_DEVICE_MODE (BIT(4) | BIT(5))
>>>>> +#define DRD_HOST_VAL 0x803
>>>>> +#define DRD_DEV_VAL 0x807
>>>>> +#define GPIO_DELAY 20
>>>>> +
>>>>> +struct ns2_phy_data;
>>>>> +struct ns2_phy_driver {
>>>>> + void __iomem *icfgdrd_regs;
>>>>> + void __iomem *idmdrd_rst_ctrl;
>>>>> + void __iomem *crmu_usb2_ctrl;
>>>>> + void __iomem *usb2h_strap_reg;
>>>>> + struct ns2_phy_data *data;
>>>>> + struct extcon_specific_cable_nb extcon_dev;
>>>>> + struct extcon_specific_cable_nb extcon_host;
>>>>
>>>> The above two members are not used in the driver.
>>>
>>> Missed out to remove them. Will do.
>>>
>>>>> + struct extcon_dev *edev;
>>>>
>>>> Does USB DRD driver waits for extcon events? If not using extcon here is bogus.
>>>
>>> DRD driver uses extcon events to disconnect/connect gadget driver runtime.
>>
>> I meant USB Device controller driver. It's not capable of DRD.
>
> all right. Btw which USB controller driver uses this?
Synopsys UDC driver currently in drivers/usb/gadget/amd5536udc.c and
drivers/usb/gadget/amd556udc_pci.c
As of 4.12.rc1 first patch (out of 6) that splits the old driver
that's PCI based is applied by the maintainer.
Rest of the patches that includes renaming the driver based on
synopsys IP and platform driver support
are to be merged yet.
>
> -Kishon
More information about the linux-arm-kernel
mailing list