[PATCH 1/2] ARM: dts: rockchip: add usb nodes on rk322x

Heiko Stuebner heiko at sntech.de
Thu Jun 1 13:22:17 PDT 2017


Hi William,

Am Mittwoch, 31. Mai 2017, 09:21:23 CEST schrieb William Wu:
> This patch adds usb otg/host controllers and phys nodes on rk322x.
> 
> Signed-off-by: William Wu <william.wu at rock-chips.com>
> ---
>  arch/arm/boot/dts/rk322x.dtsi | 138 +++++++++++++++++++++++++++++++++++++++++-
>  1 file changed, 137 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/dts/rk322x.dtsi b/arch/arm/boot/dts/rk322x.dtsi
> index df57413..d4bfd3c 100644
> --- a/arch/arm/boot/dts/rk322x.dtsi
> +++ b/arch/arm/boot/dts/rk322x.dtsi
> @@ -210,8 +210,61 @@
>  	};
>  
>  	grf: syscon at 11000000 {
> -		compatible = "syscon";
> +		compatible = "syscon", "simple-mfd";
>  		reg = <0x11000000 0x1000>;
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +
> +		u2phy0: usb2-phy at 760 {
> +			compatible = "rockchip,rk322x-usb2phy";

as commented on the driver-side some moments ago, compatibles should not
contain wildcards, so please make this
	"rockchip,rk3228-usb2phy"
instead.

Same below and also for the dwc2 node.


Thanks
Heiko

> +			reg = <0x0760 0x0c>;
> +			clocks = <&cru SCLK_OTGPHY0>;
> +			clock-names = "phyclk";
> +			#clock-cells = <0>;
> +			clock-output-names = "usb480m_phy0";
> +			status = "disabled";
> +
> +			u2phy0_otg: otg-port {
> +				#phy-cells = <0>;
> +				interrupts = <GIC_SPI 59 IRQ_TYPE_LEVEL_HIGH>,
> +					     <GIC_SPI 60 IRQ_TYPE_LEVEL_HIGH>,
> +					     <GIC_SPI 61 IRQ_TYPE_LEVEL_HIGH>;
> +				interrupt-names = "otg-bvalid", "otg-id",
> +						  "linestate";
> +				status = "disabled";
> +			};
> +
> +			u2phy0_host: host-port {
> +				#phy-cells = <0>;
> +				interrupts = <GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>;
> +				interrupt-names = "linestate";
> +				status = "disabled";
> +			};
> +		};
> +
> +		u2phy1: usb2-phy at 800 {
> +			compatible = "rockchip,rk322x-usb2phy";

rockchip,rk3228-usb2phy

> +			reg = <0x0800 0x0c>;
> +			clocks = <&cru SCLK_OTGPHY1>;
> +			clock-names = "phyclk";
> +			#clock-cells = <0>;
> +			clock-output-names = "usb480m_phy1";
> +			status = "disabled";
> +
> +			u2phy1_otg: otg-port {
> +				#phy-cells = <0>;
> +				interrupts = <GIC_SPI 68 IRQ_TYPE_LEVEL_HIGH>;
> +				interrupt-names = "linestate";
> +				status = "disabled";
> +			};
> +
> +			u2phy1_host: host-port {
> +				#phy-cells = <0>;
> +				interrupts = <GIC_SPI 69 IRQ_TYPE_LEVEL_HIGH>;
> +				interrupt-names = "linestate";
> +				status = "disabled";
> +			};
> +		};
>  	};
>  
>  	uart0: serial at 11010000 {
> @@ -467,6 +520,89 @@
>  		status = "disabled";
>  	};
>  
> +	usb_otg: usb at 30040000 {
> +		compatible = "rockchip,rk322x-usb", "rockchip,rk3066-usb",

rockchip,rk3228-usb

> +			     "snps,dwc2";
> +		reg = <0x30040000 0x40000>;
> +		interrupts = <GIC_SPI 23 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_OTG>;
> +		clock-names = "otg";
> +		dr_mode = "otg";
> +		g-np-tx-fifo-size = <16>;
> +		g-rx-fifo-size = <280>;
> +		g-tx-fifo-size = <256 128 128 64 32 16>;
> +		g-use-dma;
> +		phys = <&u2phy0_otg>;
> +		phy-names = "usb2-phy";
> +		status = "disabled";
> +	};
> +
> +	usb_host0_ehci: usb at 30080000 {
> +		compatible = "generic-ehci";
> +		reg = <0x30080000 0x20000>;
> +		interrupts = <GIC_SPI 16 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST0>, <&u2phy0>;
> +		clock-names = "usbhost", "utmi";
> +		phys = <&u2phy0_host>;
> +		phy-names = "usb";
> +		status = "disabled";
> +	};
> +
> +	usb_host0_ohci: usb at 300a0000 {
> +		compatible = "generic-ohci";
> +		reg = <0x300a0000 0x20000>;
> +		interrupts = <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST0>, <&u2phy0>;
> +		clock-names = "usbhost", "utmi";
> +		phys = <&u2phy0_host>;
> +		phy-names = "usb";
> +		status = "disabled";
> +	};
> +
> +	usb_host1_ehci: usb at 300c0000 {
> +		compatible = "generic-ehci";
> +		reg = <0x300c0000 0x20000>;
> +		interrupts = <GIC_SPI 19 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST1>, <&u2phy1>;
> +		clock-names = "usbhost", "utmi";
> +		phys = <&u2phy1_otg>;
> +		phy-names = "usb";
> +		status = "disabled";
> +	};
> +
> +	usb_host1_ohci: usb at 300e0000 {
> +		compatible = "generic-ohci";
> +		reg = <0x300e0000 0x20000>;
> +		interrupts = <GIC_SPI 20 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST1>, <&u2phy1>;
> +		clock-names = "usbhost", "utmi";
> +		phys = <&u2phy1_otg>;
> +		phy-names = "usb";
> +		status = "disabled";
> +	};
> +
> +	usb_host2_ehci: usb at 30100000 {
> +		compatible = "generic-ehci";
> +		reg = <0x30100000 0x20000>;
> +		interrupts = <GIC_SPI 66 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST2>, <&u2phy1>;
> +		phys = <&u2phy1_host>;
> +		phy-names = "usb";
> +		clock-names = "usbhost", "utmi";
> +		status = "disabled";
> +	};
> +
> +	usb_host2_ohci: usb at 30120000 {
> +		compatible = "generic-ohci";
> +		reg = <0x30120000 0x20000>;
> +		interrupts = <GIC_SPI 67 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru HCLK_HOST2>, <&u2phy1>;
> +		clock-names = "usbhost", "utmi";
> +		phys = <&u2phy1_host>;
> +		phy-names = "usb";
> +		status = "disabled";
> +	};
> +
>  	gmac: ethernet at 30200000 {
>  		compatible = "rockchip,rk3228-gmac";
>  		reg = <0x30200000 0x10000>;
> 





More information about the linux-arm-kernel mailing list