[PATCH 1/7] mtd: spi-nor: cadence-quadspi: add a delay in write sequence

Vignesh R vigneshr at ti.com
Mon Jul 31 21:54:28 PDT 2017


As per 66AK2G02 TRM[1] SPRUHY8F section 11.15.5.3 Indirect Access
Controller programming sequence, a delay equal to couple QSPI master
clock(~5ns) is required after setting CQSPI_REG_INDIRECTWR_START bit and
writing data to the flash. Add a new compatible to handle the couple of
cycles of delay required in the indirect write sequence, since this
delay is specific to TI 66AK2G SoC.

[1]http://www.ti.com/lit/ug/spruhy8f/spruhy8f.pdf

Signed-off-by: Vignesh R <vigneshr at ti.com>
---
 Documentation/devicetree/bindings/mtd/cadence-quadspi.txt |  1 +
 drivers/mtd/spi-nor/cadence-quadspi.c                     | 13 +++++++++++++
 2 files changed, 14 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
index f248056da24c..fdd511a83511 100644
--- a/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
+++ b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
@@ -2,6 +2,7 @@
 
 Required properties:
 - compatible : Should be "cdns,qspi-nor".
+	       Should be "ti,k2g-qspi" for TI 66AK2G platform.
 - reg : Contains two entries, each of which is a tuple consisting of a
 	physical address and length. The first entry is the address and
 	length of the controller register set. The second entry is the
diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
index 53c7d8e0327a..94571590371d 100644
--- a/drivers/mtd/spi-nor/cadence-quadspi.c
+++ b/drivers/mtd/spi-nor/cadence-quadspi.c
@@ -76,6 +76,7 @@ struct cqspi_st {
 	u32			fifo_depth;
 	u32			fifo_width;
 	u32			trigger_address;
+	u32			wr_delay;
 	struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
 };
 
@@ -608,6 +609,14 @@ static int cqspi_indirect_write_execute(struct spi_nor *nor,
 	reinit_completion(&cqspi->transfer_complete);
 	writel(CQSPI_REG_INDIRECTWR_START_MASK,
 	       reg_base + CQSPI_REG_INDIRECTWR);
+	/*
+	 * As per 66AK2G02 TRM SPRUHY8F section 11.15.5.3 Indirect Access
+	 * Controller programming sequence, couple of cycles of
+	 * QSPI_REF_CLK delay is required for the above bit to
+	 * be internally synchronized by the QSPI module. Provide 5
+	 * cycles of delay.
+	 */
+	ndelay(cqspi->wr_delay);
 
 	while (remaining > 0) {
 		write_bytes = remaining > page_size ? page_size : remaining;
@@ -1213,6 +1222,9 @@ static int cqspi_probe(struct platform_device *pdev)
 	}
 
 	cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
+	if (of_device_is_compatible(dev->of_node, "ti,k2g-qspi"))
+		cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
+						   cqspi->master_ref_clk_hz);
 
 	ret = devm_request_irq(dev, irq, cqspi_irq_handler, 0,
 			       pdev->name, cqspi);
@@ -1285,6 +1297,7 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
 
 static const struct of_device_id cqspi_dt_ids[] = {
 	{.compatible = "cdns,qspi-nor",},
+	{.compatible = "ti,k2g-qspi",},
 	{ /* end of table */ }
 };
 
-- 
2.13.3




More information about the linux-arm-kernel mailing list