[linux-sunxi] [PATCH 10/10] ARM: dts: sun8i: Add SY8106A regulator to Orange Pi PC

[Maxime Ripard]

Hi,

On Wed, Jul 26, 2017 at 12:23:48PM +0200, Ondřej Jirman wrote:
> Hi,
> 
> icenowy at aosc.io píše v St 26. 07. 2017 v 15:36 +0800:
> > 
> > > > > 
> > > > > Otherwse
> > > > > 
> > > > > > +               regulator-max-microvolt = <1400000>;
> > > > > > +               regulator-ramp-delay = <200>;
> > > > > 
> > > > > Is this an actual constraint of the SoC? Or is it a characteristic
> > > > > of the regulator? If it is the latter, it belongs in the driver.
> > > > > AFAIK the regulator supports varying the ramp delay (slew rate).
> > 
> > I don't know...
> > 
> > Maybe I should ask Ondrej?
> 
> It is probably neither.
> 
> It is used to calculate a delay inserted by the kernel between setting
> a new target voltage over I2C and changing the frequency of the CPU.
> The actual delay is calculated by the difference between previous and
> the new voltage.
> 
> I don't remember seeing anything in the datasheet of the regulator.
> This is just some low value that works.
> 
> It would probably be dependent on the capacitance on the output of the
> regulator, actual load (which varies), etc. So it is a board specific
> value. One could measure it with an oscilloscope if there's a need to
> optimize this.

If this is a reasonable default, then this should be in the
driver. You can't expect anyone to properly calculate a ramp delay and
have access to both a scope and the CPU power lines.

Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 801 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20170726/9e71852b/attachment.sig>