[PATCH v2 1/2] ASoC: sun4i-i2s: Add more quirks for newer SoCs

[Maxime Ripard]

Hi Markus,

On Sat, Jul 22, 2017 at 08:53:51AM +0200, codekipper at gmail.com wrote:
> From: Marcus Cooper <codekipper at gmail.com>
> 
> In preparation for changing this driver to support newer SoC
> implementations then where needed there has been a switch from
> regmap_update_bits to regmap_field. Also included are adjustment
> variables although they are not set as no adjustment is required
> for the current support.
> 
> Signed-off-by: Marcus Cooper <codekipper at gmail.com>
> ---
>  sound/soc/sunxi/sun4i-i2s.c | 267 +++++++++++++++++++++++++++++++++-----------
>  1 file changed, 203 insertions(+), 64 deletions(-)
> 
> diff --git a/sound/soc/sunxi/sun4i-i2s.c b/sound/soc/sunxi/sun4i-i2s.c
> index 62b307b0c846..1854405cbcb1 100644
> --- a/sound/soc/sunxi/sun4i-i2s.c
> +++ b/sound/soc/sunxi/sun4i-i2s.c
> @@ -50,6 +50,8 @@
>  #define SUN4I_I2S_FMT0_FMT_RIGHT_J			(2 << 0)
>  #define SUN4I_I2S_FMT0_FMT_LEFT_J			(1 << 0)
>  #define SUN4I_I2S_FMT0_FMT_I2S				(0 << 0)
> +#define SUN4I_I2S_FMT0_POLARITY_INVERTED		(1)
> +#define SUN4I_I2S_FMT0_POLARITY_NORMAL			(0)
>  
>  #define SUN4I_I2S_FMT1_REG		0x08
>  #define SUN4I_I2S_FIFO_TX_REG		0x0c
> @@ -72,7 +74,7 @@
>  #define SUN4I_I2S_INT_STA_REG		0x20
>  
>  #define SUN4I_I2S_CLK_DIV_REG		0x24
> -#define SUN4I_I2S_CLK_DIV_MCLK_EN		BIT(7)
> +#define SUN4I_I2S_CLK_DIV_MCLK_EN		7
>  #define SUN4I_I2S_CLK_DIV_BCLK_MASK		GENMASK(6, 4)
>  #define SUN4I_I2S_CLK_DIV_BCLK(bclk)			((bclk) << 4)
>  #define SUN4I_I2S_CLK_DIV_MCLK_MASK		GENMASK(3, 0)
> @@ -82,15 +84,39 @@
>  #define SUN4I_I2S_TX_CNT_REG		0x2c
>  
>  #define SUN4I_I2S_TX_CHAN_SEL_REG	0x30
> -#define SUN4I_I2S_TX_CHAN_SEL(num_chan)		(((num_chan) - 1) << 0)
> +#define SUN4I_I2S_CHAN_SEL(num_chan)		(((num_chan) - 1) << 0)
>  
>  #define SUN4I_I2S_TX_CHAN_MAP_REG	0x34
>  #define SUN4I_I2S_TX_CHAN_MAP(chan, sample)	((sample) << (chan << 2))
> +#define SUN4I_I2S_TX_CHAN_EN(num_chan)		(((1 << num_chan) - 1))
>  
>  #define SUN4I_I2S_RX_CHAN_SEL_REG	0x38
>  #define SUN4I_I2S_RX_CHAN_MAP_REG	0x3c
>  
> +struct sun4i_i2s_quirks {
> +	bool				has_reset;
> +	bool				has_master_slave_sel;

I think both variants have a master and slave mode, so it's a bit
misleading.

You should also have a kerneldoc for that structure, to make it clear
what each quirk is supposed to be doing.

> +	unsigned int			reg_offset_txdata;	/* TX FIFO */
> +	unsigned int			reg_offset_txchanmap;
> +	unsigned int			reg_offset_rxchanmap;

Is there any reason for txchanmap and rxchanmap to not be
regmap_fields too?

> +	const struct regmap_config	*sun4i_i2s_regmap;
> +	unsigned int			mclk_adjust;
> +	unsigned int			bclk_adjust;
> +	unsigned int			fmt_adjust;

I would replace adjust by offset

> +	/* Register fields for i2s */
> +	struct reg_field		field_clkdiv_mclk_en;
> +	struct reg_field		field_fmt_set_wss;
> +	struct reg_field		field_fmt_set_sr;
> +	struct reg_field		field_fmt_set_bclk_polarity;
> +	struct reg_field		field_fmt_set_lrclk_polarity;
> +	struct reg_field		field_fmt_set_mode;
> +	struct reg_field		field_txchansel;
> +	struct reg_field		field_rxchansel;
> +};
> +
>  struct sun4i_i2s {
> +	struct device	*dev;

You never use it outside of the probe function (and its callee), you
can just pass it directly as an argument

>  	struct clk	*bus_clk;
>  	struct clk	*mod_clk;
>  	struct regmap	*regmap;
> @@ -100,6 +126,18 @@ struct sun4i_i2s {
>  
>  	struct snd_dmaengine_dai_dma_data	capture_dma_data;
>  	struct snd_dmaengine_dai_dma_data	playback_dma_data;
> +
> +	/* Register fields for i2s */
> +	struct regmap_field	*field_clkdiv_mclk_en;
> +	struct regmap_field	*field_fmt_set_wss;
> +	struct regmap_field	*field_fmt_set_sr;
> +	struct regmap_field	*field_fmt_set_bclk_polarity;
> +	struct regmap_field	*field_fmt_set_lrclk_polarity;
> +	struct regmap_field	*field_fmt_set_mode;
> +	struct regmap_field	*field_txchansel;
> +	struct regmap_field	*field_rxchansel;
> +
> +	const struct sun4i_i2s_quirks	*variant;
>  };
>  
>  struct sun4i_i2s_clk_div {
> @@ -138,7 +176,7 @@ static int sun4i_i2s_get_bclk_div(struct sun4i_i2s *i2s,
>  		const struct sun4i_i2s_clk_div *bdiv = &sun4i_i2s_bclk_div[i];
>  
>  		if (bdiv->div == div)
> -			return bdiv->val;
> +			return bdiv->val + i2s->variant->bclk_adjust;
>  	}
>  
>  	return -EINVAL;
> @@ -156,7 +194,7 @@ static int sun4i_i2s_get_mclk_div(struct sun4i_i2s *i2s,
>  		const struct sun4i_i2s_clk_div *mdiv = &sun4i_i2s_mclk_div[i];
>  
>  		if (mdiv->div == div)
> -			return mdiv->val;
> +			return mdiv->val + i2s->variant->mclk_adjust;

Could you split all that work to make it a bit easier to review?

You could do so by adding the various quirks in several steps, like
first the adjusts/offsets, then the regmap_fields then the TX FIFO
(and I guess RX too?), etc.

It looks much better otherwise, thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 801 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20170725/dcb6987a/attachment.sig>