[PATCH v5 0/2] add UniPhier thermal support

[Masahiro Yamada]

2017-07-21 20:21 GMT+09:00 Kunihiko Hayashi <hayashi.kunihiko at socionext.com>:
> This series adds support for CPU temperature monitor modules implemented
> on UniPhier LD20 and PXs2 SoCs. This driver supports temperature monitoring
> and alert function on the module.
>
> Changes in v4:
> - fix warnings from sparse by replacing u32 with __be32

Nit.

Your subject prefix indicates this patch is v5.

Do you mean "Changes in v5" or "Changes since v4" ?






> Changes in v3:
> - remove TMOD_MASK and use TMOD_WIDTH representing the bit width of TMOD
>
> Changes in v2:
> - add nsleep after starting and stopping PVT
> - replace temperature calculation with sign_extend32()
>
> Changes in v1:
> - separate dts from this patchset as another patchset
> - remove 'reg' description on the dt-bindings document
> - fix the order of calling initialization functions
> - replace mask bits to use GENMASK
> - fix calculation of temperature because of not considering a negative value
> - use devm_request_threaded_irq() instead of devm_request_irq() and
>   separate a thread function from the interrupt handler
> - add dependency to Kconfig
> - set 120C to CRITICAL_TEMP_LIMIT as maximum temperature
> - shrink each line of parameters to save the number of lines
> - improve some comments and copyright description
>
> Kunihiko Hayashi (2):
>   dt-bindings: thermal: add binding documentation for UniPhier thermal
>     monitor
>   thermal: uniphier: add UniPhier thermal driver
>
>  .../bindings/thermal/uniphier-thermal.txt          |  64 ++++
>  drivers/thermal/Kconfig                            |   8 +
>  drivers/thermal/Makefile                           |   1 +
>  drivers/thermal/uniphier_thermal.c                 | 386 +++++++++++++++++++++
>  4 files changed, 459 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/thermal/uniphier-thermal.txt
>  create mode 100644 drivers/thermal/uniphier_thermal.c
>
> --
> 2.7.4
>



-- 
Best Regards
Masahiro Yamada