[PATCH 0/6] FlexRM driver improvements

[Anup Patel]

On Wed, Jul 19, 2017 at 3:25 PM, Anup Patel <anup.patel at broadcom.com> wrote:
> This patchset does various improvments to Broadcom FlexRM
> mailbox controller driver and also adds FlexRM DT nodes
> for Stingray SOC.
>
> The patches are based on Linux-4.13-rc1 and can also be
> found at flexrm-imp-v1 branch of
> https://github.com/Broadcom/arm64-linux.git
>
> Anup Patel (6):
>   mailbox: bcm-flexrm-mailbox: Set IRQ affinity hint for FlexRM ring
>     IRQs
>   mailbox: bcm-flexrm-mailbox: Add debugfs support
>   mailbox: bcm-flexrm-mailbox: Fix mask used in CMPL_START_ADDR_VALUE()
>   mailbox: Make message send queue size dynamic in Linux mailbox
>   mailbox: bcm-flexrm-mailbox: Set msg_queue_len for each channel
>   arm64: dts: Add FlexRM DT nodes for Stingray

One patch was missed-out in this series which was about
using bitmap instead of IDA to avoid locking issues. I will
send revised patchset to include this patch.

>
>  .../boot/dts/broadcom/stingray/stingray-fs4.dtsi   |  54 +++++++
>  .../arm64/boot/dts/broadcom/stingray/stingray.dtsi |   2 +
>  drivers/mailbox/bcm-flexrm-mailbox.c               | 160 ++++++++++++++++++++-
>  drivers/mailbox/mailbox.c                          |  15 +-
>  include/linux/mailbox_controller.h                 |   5 +-
>  5 files changed, 227 insertions(+), 9 deletions(-)
>  create mode 100644 arch/arm64/boot/dts/broadcom/stingray/stingray-fs4.dtsi
>
> --
> 2.7.4
>

Regards,
Anup