[PATCH 2/4] gpio: davinci: Handle the return value of davinci_gpio_irq_setup function

[Johan Hovold]

On Tue, Jul 18, 2017 at 04:27:14PM +0530, Keerthy wrote:
> Currently davinci_gpio_irq_setup return value is ignored. Handle the
> return value appropriately.
>
> Signed-off-by: Keerthy <j-keerthy at ti.com>
> ---
>  drivers/gpio/gpio-davinci.c | 18 +++++++++++++-----
>  1 file changed, 13 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
> index 2c88054..932f270 100644
> --- a/drivers/gpio/gpio-davinci.c
> +++ b/drivers/gpio/gpio-davinci.c
> @@ -233,15 +233,23 @@ static int davinci_gpio_probe(struct platform_device *pdev)
>  		chips->regs[bank] = gpio_base + offset_array[bank];
>  
>  	ret = devm_gpiochip_add_data(dev, &chips->chip, chips);
> +	if (ret)
> +		goto err;
> +
> +	platform_set_drvdata(pdev, chips);
> +	ret = davinci_gpio_irq_setup(pdev);
>  	if (ret) {
> -		ctrl_num = 0;
> -		bank_base = 0;
> -		return ret;
> +		platform_set_drvdata(pdev, NULL);
> +		goto err;
>  	}
>  
> -	platform_set_drvdata(pdev, chips);
> -	davinci_gpio_irq_setup(pdev);
>  	return 0;

There's a separate but related bug here too as the clk_prepare_enable()
in davinci_gpio_irq_setup() is never balanced on driver unbind.

Johan