[PATCH 1/4] ARM: dts: keystone-k2g: Add PMMC node to support TI-SCI protocol

[Andrew F. Davis]

On 07/17/2017 10:28 PM, Suman Anna wrote:
> From: Nishanth Menon <nm at ti.com>
> 
> Texas Instrument's System Control Interface (TI-SCI) Message Protocol
> is implemented in Keystone 2 generation 66AK2G SoC with the PMMC entity.
> 
> Add the ti-sci node representing this 66AK2G PMMC module.
> 
> Signed-off-by: Nishanth Menon <nm at ti.com>
> [s-anna at ti.com: add unit address to DT node]
> Signed-off-by: Suman Anna <s-anna at ti.com>
> ---
>  arch/arm/boot/dts/keystone-k2g.dtsi | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/keystone-k2g.dtsi b/arch/arm/boot/dts/keystone-k2g.dtsi
> index a789f75a1ed5..7f0f4180b373 100644
> --- a/arch/arm/boot/dts/keystone-k2g.dtsi
> +++ b/arch/arm/boot/dts/keystone-k2g.dtsi
> @@ -139,5 +139,19 @@
>  			interrupts = <GIC_SPI 324 IRQ_TYPE_LEVEL_HIGH>,
>  				     <GIC_SPI 327 IRQ_TYPE_LEVEL_HIGH>;
>  		};
> +
> +		pmmc: pmmc at 02921c00 {
> +			compatible = "ti,k2g-sci";
> +			/*
> +			 * In case of rare platforms that does not use k2g as
> +			 * system master, use /delete-property/
> +			 */

This comment seems mis-worded, I believe this was meant to say "for
platforms that do not use the *PMMC* as the system master".

Andrew

> +			ti,system-reboot-controller;
> +			mbox-names = "rx", "tx";
> +			mboxes= <&msgmgr 5 2>,
> +				<&msgmgr 0 0>;
> +			reg-names = "debug_messages";
> +			reg = <0x02921c00 0x400>;
> +		};
>  	};
>  };
>