[PATCH v4 0/2] Add basic support for Mediatek MT2712 SoC

[YT Shen]

Hi Matthias,

Just a gentle ping.
Should I rebase to 4.13-rc1 and send v5?

Thanks
yt.shen

On Thu, 2017-06-22 at 17:32 +0800, YT Shen wrote:
> MT2712 is a SoC based on 64bit ARMv8 architecture.
> MT2712 share many HW IP with MT8173.  This patchset was tested on MT2712 evaluation board, and boot to shell ok.
> 
> This series contains document bindings, device tree including interrupt and uart.
> 
> Changes compared to v3:
> - use two uart clocks refer to the bindings
> 
> Changes compared to v2:
> - remove alias from serial1 to serial5
> - remove initrd-start and initrd-end
> - change GIC_CPU_MASK_SIMPLE(6) to GIC_CPU_MASK_RAW(0x13)
> - change gic-400 reg range
> 
> Changes compared to v1:
> - change subject prefix for bindings
> - change device tree license to SPDX tag.
> - change bootargs parameter to DT usage.
> - change intpol-controller to interrupt-controller
> 
> YT Shen (2):
>   dt-bindings: arm: Add bindings for Mediatek MT2712 SoC Platform
>   arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and
>     Makefile
> 
>  Documentation/devicetree/bindings/arm/mediatek.txt |   4 +
>  .../interrupt-controller/mediatek,sysirq.txt       |   1 +
>  .../devicetree/bindings/serial/mtk-uart.txt        |   1 +
>  arch/arm64/boot/dts/mediatek/Makefile              |   1 +
>  arch/arm64/boot/dts/mediatek/mt2712-evb.dts        |  32 ++++
>  arch/arm64/boot/dts/mediatek/mt2712e.dtsi          | 172 +++++++++++++++++++++
>  6 files changed, 211 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/mediatek/mt2712-evb.dts
>  create mode 100644 arch/arm64/boot/dts/mediatek/mt2712e.dtsi
>