[PATCH v3 0/5] Add SoM1 support

[Ludovic Desroches]

On Thu, Jul 06, 2017 at 02:29:36PM +0200, Nicolas Ferre wrote:
> On 06/07/2017 at 10:35, Claudiu Beznea wrote:
> > Hi all,
> > 
> > This series adds support for sama5d2 SoM1 devices.
> > 
> > The at91-sama5d27_som1.dtsi add specific bindings for SoM1 board.
> > The at91-sama5d27_som1_ek.dts add specific bindings for SoM1 EK board.
> > 
> > Thank you,
> > Claudiu
> 
> You can add my:
> Acked-by: Nicolas Ferre <nicolas.ferre at microchip.com>
> 
> for the whole series.
> (I remember that we also had Ludovic's one as well).

Yes, the only comment was about the mac-offset but it has been removed
from this series and I had the technical explanation so still

Acked-by: Ludovic Desroches <ludovic.desroches at microchip.com>

> 
> Regards,
> 
> > Changes in v3:
> > - remove qspi flash mapping for the moment
> > - remove at24 and i2c bindings; this will be introduced when
> > "Add at24 functionality to read form different EEPROM offsets" patch will
> > be accepted
> > - change the title of patch 5 from this series from
> > "ARM: dts: sama5d27_som1_ek: Add sama5d27 SoM1 EK support" to
> > "ARM: dts: at91: at91-sama5d27_som1_ek: Add sama5d27 SoM1 EK support" to
> > match the desired prefix
> > 
> > Changes in v2:
> > o in at91-sama5d27_som1.dtsi:
> > - increase bootloader and kernel size in flash map (with bootloader
> > flash offset the dtb and kernel flash offsets were changed)
> > - use right pin for ethernet-phy interrupt
> > 
> > o in at91-sama5d27_som1_ek.dts:
> > - removed memory tag and rely on bootloader to fill the right value
> > - use pin macros (from arch/arm/boot/dts/sama5d2-pinfunc.h) wherever
> > posible instead of pin numbers
> > - remove pinctrl_sensor_power and pinctrl_sensor_reset pin muxing
> > since they are not of intereset for this board
> > - use "pb4" label for user button instead of "bp1"
> > 
> > Claudiu Beznea (2):
> >   ARM: dts: at91: at91-sama5d27_som1: add sama5d27 SoM1 support
> >   ARM: dts: sama5d27_som1_ek: Add sama5d27 SoM1 EK support
> > 
> > Cristian Birsan (1):
> >   drivers: soc: atmel: Add basic support for new sama5d2 SiPs
> > 
> > Cyrille Pitchen (1):
> >   ARM: dts: at91: sama5d2: add QSPI nodes
> > 
> > Songjun Wu (1):
> >   ARM: dts: at91: sama5d2: add isc node
> > 
> >  arch/arm/boot/dts/Makefile                  |   1 +
> >  arch/arm/boot/dts/at91-sama5d27_som1.dtsi   | 178 +++++++++
> >  arch/arm/boot/dts/at91-sama5d27_som1_ek.dts | 551 ++++++++++++++++++++++++++++
> >  arch/arm/boot/dts/sama5d2.dtsi              |  38 ++
> >  drivers/soc/atmel/soc.c                     |   8 +
> >  drivers/soc/atmel/soc.h                     |   4 +
> >  6 files changed, 780 insertions(+)
> >  create mode 100644 arch/arm/boot/dts/at91-sama5d27_som1.dtsi
> >  create mode 100644 arch/arm/boot/dts/at91-sama5d27_som1_ek.dts
> > 
> 
> 
> -- 
> Nicolas Ferre