[PATCH v2 1/6] serial: imx: only set DMA rx-ing when DMA starts

[Uwe Kleine-König]

On Thu, Jul 06, 2017 at 10:31:38AM +0200, Romain Perier wrote:
> Hello,
> 
> 
> Le 05/07/2017 à 15:29, Uwe Kleine-König a écrit :
> > Hello,
> >
> > On Wed, Jul 05, 2017 at 03:07:01PM +0200, Romain Perier wrote:
> >> From: Nandor Han <nandor.han at ge.com>
> >>
> >> Avoid the situation when `dma_is_rxing` could incorrectly signal that
> >> DMA RX channel is receiving data in case DMA preparation or sg mapping
> >> fails.
> >>
> >> This commit fixes the issues by moving the assignment of dma_is_rxing
> >> out of imx_disable_rx_int(), then the variable is set to 1 from
> >> start_rx_dma() only when the preparation is correctly done.
> > I'd write:
> >
> > 	There are a few issues with setting dma_is_rxing to 1 in
> > 	imx_disable_rx_int:
> >
> > 	 - Currently always after imx_disable_rx_int() the function
> > 	   start_rx_dma() is called. This dependency isn't obvious though.
> > 	 - start_rx_dma() does error checking and might exit without enabling
> > 	   DMA but keeping dma_is_rxing 1.
> >
> > 	So the more natural place for setting dma_is_rxing to 1 is in
> > 	start_rx_dma after all errors are checked.
> >
> > If you use this, there is nothing left of Nandor Han's patch and you can
> > drop his authorship.
> >
> > Best regards
> > Uwe
> >
> Ok, will do. No other feedback for the rest of the series ? (just to
> know if I send a v3 or If I wait a bit...)

I didn't come around looking in the patches I didn't comment yet.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |