[PATCH v2 1/7] DT bindings: add bindings for ov965x camera module

[Rob Herring]

On Mon, Jul 03, 2017 at 11:16:02AM +0200, Hugues Fruchet wrote:
> From: "H. Nikolaus Schaller" <hns at goldelico.com>
> 
> This adds documentation of device tree bindings
> for the OV965X family camera sensor module.
> 
> Signed-off-by: H. Nikolaus Schaller <hns at goldelico.com>
> Signed-off-by: Hugues Fruchet <hugues.fruchet at st.com>
> ---
>  .../devicetree/bindings/media/i2c/ov965x.txt       | 45 ++++++++++++++++++++++
>  1 file changed, 45 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/i2c/ov965x.txt
> 
> diff --git a/Documentation/devicetree/bindings/media/i2c/ov965x.txt b/Documentation/devicetree/bindings/media/i2c/ov965x.txt
> new file mode 100644
> index 0000000..4ceb727
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/i2c/ov965x.txt
> @@ -0,0 +1,45 @@
> +* Omnivision OV9650/9652/9655 CMOS sensor
> +
> +The Omnivision OV965x sensor support multiple resolutions output, such as
> +CIF, SVGA, UXGA. It also can support YUV422/420, RGB565/555 or raw RGB
> +output format.
> +
> +Required Properties:
> +- compatible: should be one of
> +	"ovti,ov9650"
> +	"ovti,ov9652"
> +	"ovti,ov9655"
> +- clocks: reference to the mclk input clock.
> +
> +Optional Properties:
> +- resetb-gpios: reference to the GPIO connected to the RESETB pin, if any,
> +		polarity is active low.

reset-gpios

> +- pwdn-gpios: reference to the GPIO connected to the PWDN pin, if any,
> +		polarity is active high.

powerdown-gpios

Both are standardish names for such signals.

Rob