[PATCH v9 2/3] PCI: Add tango PCIe host bridge support

Bjorn Helgaas helgaas at kernel.org
Sun Jul 2 16:18:11 PDT 2017


On Tue, Jun 20, 2017 at 10:17:40AM +0200, Marc Gonzalez wrote:
> This driver is required to work around several hardware bugs
> in the PCIe controller.
> 
> NB: Revision 1 does not support legacy interrupts, or IO space.

I had to apply these manually because of conflicts in Kconfig and
Makefile.  What are these based on?  Easiest for me is if you base
them on the current -rc1 tag.

> Signed-off-by: Marc Gonzalez <marc_gonzalez at sigmadesigns.com>
> ---
>  drivers/pci/host/Kconfig      |   8 +++
>  drivers/pci/host/Makefile     |   1 +
>  drivers/pci/host/pcie-tango.c | 164 ++++++++++++++++++++++++++++++++++++++++++
>  include/linux/pci_ids.h       |   2 +
>  4 files changed, 175 insertions(+)
>  create mode 100644 drivers/pci/host/pcie-tango.c
> 
> diff --git a/drivers/pci/host/Kconfig b/drivers/pci/host/Kconfig
> index d7e7c0a827c3..5183d9095c3a 100644
> --- a/drivers/pci/host/Kconfig
> +++ b/drivers/pci/host/Kconfig
> @@ -285,6 +285,14 @@ config PCIE_ROCKCHIP
>  	  There is 1 internal PCIe port available to support GEN2 with
>  	  4 slots.
>  
> +config PCIE_TANGO
> +	bool "Tango PCIe controller"
> +	depends on ARCH_TANGO && PCI_MSI && OF
> +	select PCI_HOST_COMMON
> +	help
> +	  Say Y here to enable PCIe controller support for Sigma Designs
> +	  Tango systems, such as SMP8759 and later chips.
> +
>  config VMD
>  	depends on PCI_MSI && X86_64
>  	tristate "Intel Volume Management Device Driver"
> diff --git a/drivers/pci/host/Makefile b/drivers/pci/host/Makefile
> index 084cb4983645..fc7ea90196f3 100644
> --- a/drivers/pci/host/Makefile
> +++ b/drivers/pci/host/Makefile
> @@ -32,4 +32,5 @@ obj-$(CONFIG_PCI_HOST_THUNDER_PEM) += pci-thunder-pem.o
>  obj-$(CONFIG_PCIE_ARMADA_8K) += pcie-armada8k.o
>  obj-$(CONFIG_PCIE_ARTPEC6) += pcie-artpec6.o
>  obj-$(CONFIG_PCIE_ROCKCHIP) += pcie-rockchip.o
> +obj-$(CONFIG_PCIE_TANGO) += pcie-tango.o
>  obj-$(CONFIG_VMD) += vmd.o
> diff --git a/drivers/pci/host/pcie-tango.c b/drivers/pci/host/pcie-tango.c
> new file mode 100644
> index 000000000000..67aaadcc1c5e
> --- /dev/null
> +++ b/drivers/pci/host/pcie-tango.c
> @@ -0,0 +1,164 @@
> +#include <linux/pci-ecam.h>
> +#include <linux/delay.h>
> +#include <linux/of.h>
> +
> +#define MSI_MAX 256
> +
> +#define SMP8759_MUX		0x48
> +#define SMP8759_TEST_OUT	0x74
> +
> +struct tango_pcie {
> +	void __iomem *mux;
> +};
> +
> +/*** HOST BRIDGE SUPPORT ***/
> +
> +static int smp8759_config_read(struct pci_bus *bus,
> +		unsigned int devfn, int where, int size, u32 *val)

Wrap these with as much as possible on the first line, e.g.,

  static int smp8759_config_read(struct pci_bus *bus, unsigned int devfn,
                                 int where, int size, u32 *val)


> +{
> +	int ret;
> +	struct pci_config_window *cfg = bus->sysdata;
> +	struct tango_pcie *pcie = dev_get_drvdata(cfg->parent);

Reorder as:

        struct pci_config_window *cfg = bus->sysdata;
        struct tango_pcie *pcie = dev_get_drvdata(cfg->parent);
        int ret;

> +
> +	/*
> +	 * QUIRK #1

Omit "QUIRK #1", "QUIRK #2", etc unless they're actual references to an errata
document.

> +	 * Reads in configuration space outside devfn 0 return garbage.
> +	 */
> +	if (devfn != 0)
> +		return PCIBIOS_FUNC_NOT_SUPPORTED;
> +
> +	/*
> +	 * QUIRK #2
> +	 * Unfortunately, config and mem spaces are muxed.
> +	 * Linux does not support such a setting, since drivers are free
> +	 * to access mem space directly, at any time.
> +	 * Therefore, we can only PRAY that config and mem space accesses
> +	 * NEVER occur concurrently.
> +	 */
> +	writel_relaxed(1, pcie->mux);
> +	ret = pci_generic_config_read(bus, devfn, where, size, val);
> +	writel_relaxed(0, pcie->mux);

I'm very hesitant about this.  When people stress this, we're going to
get reports of data corruption.  Even with the disclaimer below, I
don't feel good about this.  Adding the driver is an implicit claim
that we support the device, but we know it can't be made reliable.

What is the benefit of adding this driver?  How many units are in the
field?  Are you hoping to have support in distros like RHEL?  Are
these running self-built kernels straight from kernel.org?  Is it
feasible for you to distribute this driver separately from the
upstream kernel?

> +	return ret;
> +}
> +
> +static int smp8759_config_write(struct pci_bus *bus,
> +		unsigned int devfn, int where, int size, u32 val)
> +{
> +	int ret;
> +	struct pci_config_window *cfg = bus->sysdata;
> +	struct tango_pcie *pcie = dev_get_drvdata(cfg->parent);
> +
> +	writel_relaxed(1, pcie->mux);
> +	ret = pci_generic_config_write(bus, devfn, where, size, val);
> +	writel_relaxed(0, pcie->mux);
> +
> +	return ret;
> +}
> +
> +static struct pci_ecam_ops smp8759_ecam_ops = {
> +	.bus_shift	= 20,
> +	.pci_ops	= {
> +		.map_bus	= pci_ecam_map_bus,
> +		.read		= smp8759_config_read,
> +		.write		= smp8759_config_write,
> +	}
> +};
> +
> +static const struct of_device_id tango_pcie_ids[] = {
> +	{ .compatible = "sigma,smp8759-pcie" },
> +	{ /* sentinel */ },
> +};

Move table down to point where it's needed.

> +static int tango_check_pcie_link(void __iomem *test_out)

I think this is checking for link up.  Rename to tango_pcie_link_up()
to follow the convention of other drivers.  Take a struct tango_pcie *
instead of an address, if possible.

> +{
> +	int i;
> +
> +	writel_relaxed(16, test_out);
> +	for (i = 0; i < 10; ++i) {
> +		u32 ltssm_state = readl_relaxed(test_out) >> 8;
> +		if ((ltssm_state & 0x1f) == 0xf) /* L0 */
> +			return 0;
> +		usleep_range(3000, 4000);
> +	}
> +
> +	return -ENODEV;
> +}
> +
> +static int smp8759_init(struct tango_pcie *pcie, void __iomem *base)
> +{
> +	pcie->mux		= base + SMP8759_MUX;
> +
> +	return tango_check_pcie_link(base + SMP8759_TEST_OUT);
> +}
> +
> +static int tango_pcie_probe(struct platform_device *pdev)
> +{
> +	int ret = -EINVAL;
> +	void __iomem *base;
> +	struct resource *res;
> +	struct tango_pcie *pcie;
> +	struct device *dev = &pdev->dev;

Reverse declaration order.  Then they'll be declared in order of use.

> +	pr_err("MAJOR ISSUE: PCIe config and mem spaces are muxed\n");
> +	pr_err("Tainting kernel... Use driver at your own risk\n");

These should be dev_err().

> +	add_taint(TAINT_FIRMWARE_WORKAROUND, LOCKDEP_STILL_OK);
> +
> +	pcie = devm_kzalloc(dev, sizeof(*pcie), GFP_KERNEL);
> +	if (!pcie)
> +		return -ENOMEM;
> +
> +	platform_set_drvdata(pdev, pcie);

Minor style: move this down to the end, so we're not associating an
uninitialized drvdata structure with the pdev.  Better to wait until
it's fully initialized.

> +	res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
> +	base = devm_ioremap_resource(&pdev->dev, res);

Use "dev", not "&pdev->dev".

> +	if (IS_ERR(base))
> +		return PTR_ERR(base);
> +
> +	if (of_device_is_compatible(dev->of_node, "sigma,smp8759-pcie"))

Not necessary, since tango_pcie_ids[] only contains
"sigma,smp8759-pcie".  If/when you need different init for different
versions, you can add something like this back, and it will be obvious
why it's needed.  Right now, there's no need for this, so it looks out
of place.

> +		ret = smp8759_init(pcie, base);
> +
> +	if (ret)
> +		return ret;
> +
> +	return pci_host_common_probe(pdev, &smp8759_ecam_ops);
> +}
> +
> +static struct platform_driver tango_pcie_driver = {
> +	.probe	= tango_pcie_probe,
> +	.driver	= {
> +		.name = KBUILD_MODNAME,
> +		.of_match_table = tango_pcie_ids,

I think you need ".suppress_bind_attrs = true" here to prevent issues
when unbinding driver.  See
http://git.kernel.org/cgit/linux/kernel/git/torvalds/linux.git/commit/?id=a5f40e8098fe

> +	},
> +};
> +

Remove blank line.

> +builtin_platform_driver(tango_pcie_driver);
> +
> +/*
> + * QUIRK #3
> + * The root complex advertizes the wrong device class.

s/advertizes/advertises/

> + * Header Type 1 is for PCI-to-PCI bridges.
> + */
> +static void tango_fixup_class(struct pci_dev *dev)
> +{
> +	dev->class = PCI_CLASS_BRIDGE_PCI << 8;
> +}
> +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SIGMA, 0x24, tango_fixup_class);
> +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SIGMA, 0x28, tango_fixup_class);
> +
> +/*
> + * QUIRK #4
> + * The root complex exposes a "fake" BAR, which is used to filter
> + * bus-to-system accesses. Only accesses within the range defined
> + * by this BAR are forwarded to the host, others are ignored.
> + *
> + * By default, the DMA framework expects an identity mapping,
> + * and DRAM0 is mapped at 0x80000000.
> + */
> +static void tango_fixup_bar(struct pci_dev *dev)
> +{
> +	dev->non_compliant_bars = true;
> +	pci_write_config_dword(dev, PCI_BASE_ADDRESS_0, 0x80000000);
> +}
> +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SIGMA, 0x24, tango_fixup_bar);
> +DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SIGMA, 0x28, tango_fixup_bar);
> diff --git a/include/linux/pci_ids.h b/include/linux/pci_ids.h
> index f020ab4079d3..b577dbe46f8f 100644
> --- a/include/linux/pci_ids.h
> +++ b/include/linux/pci_ids.h
> @@ -1369,6 +1369,8 @@
>  #define PCI_DEVICE_ID_TTI_HPT374	0x0008
>  #define PCI_DEVICE_ID_TTI_HPT372N	0x0009	/* apparently a 372N variant? */
>  
> +#define PCI_VENDOR_ID_SIGMA		0x1105
> +
>  #define PCI_VENDOR_ID_VIA		0x1106
>  #define PCI_DEVICE_ID_VIA_8763_0	0x0198
>  #define PCI_DEVICE_ID_VIA_8380_0	0x0204
> -- 
> 2.11.0
> 



More information about the linux-arm-kernel mailing list