[PATCH 2/8] pinctrl: stm32: use gpio-ranges to declare bank range

[Linus Walleij]

On Fri, Jan 27, 2017 at 5:15 PM, Alexandre TORGUE
<alexandre.torgue at st.com> wrote:

> Use device tree entries to declare gpio range. It will allow to use
> no contiguous gpio bank and holes inside a bank.
>
> Signed-off-by: Alexandre TORGUE <alexandre.torgue at st.com>

(...)
> +       of_property_read_string(np, "st,bank-name", &bank->gpio_chip.label);
> +
> +       if (!of_parse_phandle_with_fixed_args(np, "gpio-ranges", 3, 0, &args))
> +               bank_nr = args.args[1] / STM32_GPIO_PINS_PER_BANK;
> +       else {
> +               range->name = bank->gpio_chip.label;
> +               range->id = bank_nr;
> +               range->pin_base = range->id * STM32_GPIO_PINS_PER_BANK;
> +               range->base = range->id * STM32_GPIO_PINS_PER_BANK;
> +               range->npins = npins;
> +               range->gc = &bank->gpio_chip;
> +               pinctrl_add_gpio_range(pctl->pctl_dev,
> +                                      &pctl->banks[bank_nr].range);
> +       }

Why are you doing this?

There is already code in drivers/gpio/gpiolib-of.c to pick ranges
from the device tree and add when you're adding the GPIO chips.

Please use that or figure out what is needed to make it work for
you instead of reimplementing it.

Yours,
Linus Walleij