[STLinux Kernel] [PATCH 7/8] ARM: dts: STiH407-family: Use new Pinctrl groups

[Lee Jones]

On Wed, 25 Jan 2017, Peter Griffin wrote:

> Hi Lee,
> 
> On Tue, 24 Jan 2017, Lee Jones wrote:
> 
> > Having just defined some new Pinctrl groups for when when HW flow-
> > control is {en,dis}abled, let's reference them for use within the
> > driver.
> > 
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> Same as previous comment, your enabling hw flow control for all
> stih407 family boards. I've not checked the schematics for them
> but as hw flow control is dependent on board wiring, IMO this
> should be added in board specific file.

Fair shout.

On the B2120 UART0 is hooked up to the Smart Card Reader.

Will fix.

> > ---
> >  arch/arm/boot/dts/stih407-family.dtsi | 5 +++--
> >  1 file changed, 3 insertions(+), 2 deletions(-)
> > 
> > diff --git a/arch/arm/boot/dts/stih407-family.dtsi b/arch/arm/boot/dts/stih407-family.dtsi
> > index c8b2944..9789978 100644
> > --- a/arch/arm/boot/dts/stih407-family.dtsi
> > +++ b/arch/arm/boot/dts/stih407-family.dtsi
> > @@ -222,8 +222,9 @@
> >  			compatible = "st,asc";
> >  			reg = <0x9830000 0x2c>;
> >  			interrupts = <GIC_SPI 122 IRQ_TYPE_NONE>;
> > -			pinctrl-names = "default";
> > -			pinctrl-0 = <&pinctrl_serial0>;
> > +			pinctrl-names = "default", "manual-rts";
> > +			pinctrl-0 = <&pinctrl_serial0_flowctrl>;
> > +			pinctrl-1 = <&pinctrl_serial0>;
> >  			clocks = <&clk_s_c0_flexgen CLK_EXT2F_A9>;
> >  
> >  			status = "disabled";

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog