[PATCH] pinctrl: sunxi: Don't enforce bias disable (for now)

[Maxime Ripard]

Commit 07fe64ba213f ("pinctrl: sunxi: Handle bias disable") actually
enforced enforced the disabling of the pull up/down resistors instead of
ignoring it like it was done before.

This was part of a wider rework to switch to the generic pinconf bindings,
and was meant to be merged together with DT patches that were switching to
it, and removing what was considered default values by both the binding and
the boards. This included no bias on a pin.

However, those DT patches were delayed to 4.11, which would be fine only
for a significant number boards having the bias setup wrong, which in turns
break the MMC on those boards (and possibly other devices too).

In order to avoid conflicts as much as possible, bring back the old
behaviour for 4.10, and we'll revert that commit once all the DT bits will
have landed.

Tested-by: Priit Laes <plaes at plaes.org>
Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
---
Hi Linus,

This is intended as a fix for 4.10.

Thanks!
Maxime

 drivers/pinctrl/sunxi/pinctrl-sunxi.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index 0eb51e33cb1b..207a8de4e1ed 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
@@ -564,8 +564,7 @@ static int sunxi_pconf_group_set(struct pinctrl_dev *pctldev,
 			val = arg / 10 - 1;
 			break;
 		case PIN_CONFIG_BIAS_DISABLE:
-			val = 0;
-			break;
+			continue;
 		case PIN_CONFIG_BIAS_PULL_UP:
 			if (arg == 0)
 				return -EINVAL;
-- 
2.11.0