[PATCH 0/5] meson-gx: reset RGMII PHYs and configure TX delay

[Jerome Brunet]

On Wed, 2017-01-18 at 20:40 +0100, Martin Blumenstingl wrote:
> Kevin,
> 
> On Wed, Jan 18, 2017 at 8:28 PM, Kevin Hilman <khilman at baylibre.com>
> wrote:
> > 
> > Martin Blumenstingl <martin.blumenstingl at googlemail.com> writes:
> > 
> > > 
> > > This partially fixes the 1000Mbit/s ethernet TX throughput issues
> > > (on
> > > networks which are not affected by the EEE problem, as reported
> > > here:
> > 
> > Based on the discussions with Jerome, I'm dropping this series from
> > the
> > v4.11/dt64 branch for now.
> what is you opinion on having the MDIO node in meson-gx (and keeping
> GXBB and GXL/GXM consistent) vs not having PHY autodetection for GXBB
> (= not having the MDIO in meson-gx)?
> I cannot send a v2 until we have a decision for this
> 
> > 
> > This series also had a small conflict with Jerome's fix[1] for the
> > odroid-c2, so please rebase any updates here on my v4.10/fixes
> > branch.
> will keep that in mind, noted.
Most this patch can go away with your patch.
Just make sure to keep "eee-broken-1000t;" in the odroidc2 dtsi and
it'll be OK.

> _______________________________________________
> linux-amlogic mailing list
> linux-amlogic at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-amlogic