[PATCH 3/3] arm64: dts: exynos: Use macros for pinctrl configuration on Exynos7

[Krzysztof Kozlowski]

On Wed, Jan 18, 2017 at 11:12:21AM +0530, Pankaj Dubey wrote:
> Usage of DTS macros instead of hard-coded numbers makes code easier to
> read.  One does not have to remember which value means pull-up/down or
> specific driver strength.
> 
> Signed-off-by: Pankaj Dubey <pankaj.dubey at samsung.com>
> ---
>  arch/arm64/boot/dts/exynos/exynos7-espresso.dts |   4 +-
>  arch/arm64/boot/dts/exynos/exynos7-pinctrl.dtsi | 302 ++++++++++++------------
>  2 files changed, 154 insertions(+), 152 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
> index c528dd5..1b2db9f0 100644
> --- a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
> +++ b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
> @@ -328,8 +328,8 @@
>  &pinctrl_alive {
>  	pmic_irq: pmic-irq {
>  		samsung,pins = "gpa0-2";
> -		samsung,pin-pud = <3>;
> -		samsung,pin-drv = <3>;
> +		samsung,pin-pud = <EXYNOS_PIN_PULL_UP>;
> +		samsung,pin-drv = <EXYNOS4_PIN_DRV_LV3>;
>  	};
>  };

This is not equal (value 3 => 1). If the change was intended, please do
in separate patch.

Rest looks fine.

Best regards,
Krzysztof