[PATCH] ARM: dts: imx6q-utilite-pro: enable 2nd display pipeline

[Christopher Spinrath]

Hi Philipp,

thanks for the review!

On 01/17/2017 09:57 AM, Philipp Zabel wrote:
> [...]
>> +
>> +	parallel-display {
>> +		compatible = "fsl,imx-parallel-display";
>> +		#address-cells = <1>;
>> +		#size-cells = <0>;
>> +		pinctrl-names = "default";
>> +		pinctrl-0 = <&pinctrl_ipu1>;
>> +
>> +		interface-pix-fmt = "rgb24";
>
> This is not necessary if the connector created by the tpf410 has the
> correct media bus format set in its display_info structure. This can be
> done in tfp410_attach, before calling drm_mode_connector_attach_encoder:
>
>         u32 bus_format = MEDIA_BUS_FMT_RGB888_1X24;
>
> 	drm_display_info_set_bus_formats(&dvi->connector.display_info,
> 					 &bus_format, 1);
>
> After this is done, the above line should be removed in a follow-up
> patch.

Ok, I will send a mini follow-up series doing that with your 
Suggested-by (unless you object) in the next few days.

Cheers,
Christopher

>> +		port at 0 {
>> +			reg = <0>;
>> +
>> +			parallel_display_in: endpoint {
>> +				remote-endpoint = <&ipu1_di0_disp0>;
>> +			};
>> +		};
>> +
>> +		port at 1 {
>> +			reg = <1>;
>> +
>> +			parallel_display_out: endpoint {
>> +				remote-endpoint = <&tfp410_in>;
>> +			};
>> +		};
>> +	};
>>  };
>>  [...]